Husqvarna T540 Mark III Carb Replacement

Рет қаралды 1,070

2 ай бұрын

In this video I will show you a Husqvarna T540 Mark III chainsaw and how to replace the carb. This procedure is different than the previous versions of this saw. #smallenginerepair
If you would like to support the channel by purchasing stickers, you can do that here: www.ebay.com/str/thegreasysho...
If you would like to support the channel by purchasing a carburetor stand, you can find them here: www.ebay.com/str/thegreasysho...

Пікірлер: 20

@wayneberry8703 2 ай бұрын

Great job, Scott 👍🏼.

@steveriggenbach90 2 ай бұрын

Thanks for demystifying things. People are getting in the middle. The old parts cost a fortune and are hard to find. Can’t afford the new stuff. Got a whole group now that are using any junk saws they can find. Same as cars.

@richardflagg3084 2 ай бұрын

It's nearly impossible to make this procedure look graceful. Nice work with the editing and no need to apologize about fumbling around. There's nothing hard about it, just very tedious.

@TheGreasyShopRag 2 ай бұрын

Thanks. I guess the point of making this video was to show that this new T540 is built different than the old versions. You're right, it is a bit tedious but the next one gets easier and so on.

@noelstractors-firewood57 2 ай бұрын

Neat video.

@TheGreasyShopRag 2 ай бұрын

Thanks for watching!

@chrischiampo7647 2 ай бұрын

Nice Job Brother Can a Carb Be Swapped Without The Firmware Update If You Dont Have The New Firmware Tool Like a Manual Relearn ? 😎

@MarkOxley-vo3kq 2 ай бұрын

Good to know. 👍

@tedneitzel 2 ай бұрын

Good repair. Hope that fixed the issues!

@TheGreasyShopRag 2 ай бұрын

Me too!

@thomasfrost6993 2 ай бұрын

Sad to see "software" now in chainsaws. So much for do it yourself repair on the carb.

@TheGreasyShopRag 2 ай бұрын

You can still disassemble and clean the carb. Its the autotune module bolted to it that needs firmware updates.

@casey74500 2 ай бұрын

love your channel, can you do a vid on how to remove a clutch on a 572xp? can you recommend a tool ?

@TheGreasyShopRag 2 ай бұрын

The official husqvarna clutch tool is part #597370701.

@PelicanIslandLabs 2 ай бұрын

Any idea why a new carb needed replacement?

@TheGreasyShopRag 2 ай бұрын

It had an intermittent running issue. I did all the usual tests and pressure/vacuum test and found nothing wrong. Replaced a lot of parts and still nothing. Then I found a pinched wire that ran from the coil to the autotune module and was certain this was the issue but was proven wrong. The carb/autotune module was the only thing left to try. It ran good for me but the customer just picked up the saw and needs to confirm it.