Are we supposed be believe this was filmed in 1960,or am I missing something? It’s still pretty good.

Very impressive. Congratulations this is the sort of work the grand-father of our grad-father knew how to do by memory.

Fabulous ! I loved the 'drop hammer'

8:56 they hammer the big bearing - we used to heat them first so they just slid on! Someone needs to teach these guys about thermal expansions and cooling!

For the conditions that you guys work in you do a good job getting the job done.

For those who don't know that's a flying shear for a hot steel rolling mill that gear is almost never in continuous motion, putting a paper gasket on a bearing block is madness though

You guys get it done.

I used to make gearboxes just like this in 1985-1990.

My respect for those hard workers, without the tools we use in different Country, the only thing I can't believing they do not use any safety gear, like hard hats, safety glasses, boots with steel toes. Guys wear safety gear in that gearbox Factory.

bravo

Kebahagiaan dlm kerja

good thing they are all wearing their saftey sandals.

Egal mit welchen Mitteln. Diese Männer können noch etwas.

🙏Good Job people 🌎🇺🇸✊

Nice work👍👍😀😀

Should have put some grease nipples or a one way check valve auto greasing canister.......bearings and bushings always need more grease

I don't understand the "great work" comments I see on these type of videos. This is a field repair not a precision rebuild. Will it function? Yes. I cannot understand why these people all work in such filthy conditions. It does not cost to clean up the junk and work area.

بسم الله ماشاء الله

heat those big bearings to almost hot coffee heat and they will expand about 6 thou and slide on.

these guys move things that are hundreds of pounds. weld, grind - in sandals.

jajajajajajaj....cero....estrés.... saludos

Heavy duty but crudely built, there has to be a ton of stress on that cast gear with the shaft driven like that. No doubt this shop was the low bidder for that steel bar cutter.

they actually don't understsand about thermal expansion of steel so they have to do an awful lot of slam fitting with great weights.

1:50 楽しそうで草😂

GOD

Let the shop manager still buy a hydraulic press. Hammering into a gear like a shaft, it's tough.🤔

É tudo na marra, poderia ter uma máquina hidráulica pra assentar essas peças.

Show...

next time heat the bearing to 80-90 degrees, it will fit you without a hammer. Regards

0:00 is that the new employee incentive program?

assalam alaikum sir ji where is the address of your factory

Working heavy industry wearing p.j.s and house shoes

this way of assembling is fully forbiden technically :you chould never hammering the bearings ;the fonctional clearance will increases andreduces them life

Шутка: самое главное - замазаться краской

Location?

что творят? нагреть не пробовали?

The guy in the red cap has work gloves--he's spoilt!

someone in Pakistan needs to invent sweeping brushes to try walking on a clean floor?????????????

Ma si rendono conto che mettono i cuscinetti a martellate, metteteli in galera

those horses look human.. haha

😂😂😂😂😅😅😅😅😅😅😊😊😊

More slobbering, why don't you guys that are supposed to be engineers try to make where you work a bit more user friendly, clear the rubbish from the floor, everything you leave down picks up the dirt and transfers it to what you are working on, why can't ye make up a frame for a hydraulic press, it maybe that whoever owns the business is doing the work for nothing and it's a charity shop?, if so I will donate a broom so ye can sweep the floor.

Schweinestall.