The carburetor comes out super easy. There's only 3 jets inside there. A small one, just a cap jet. Of fen long one, which is a airflower and in your Manja, it's very simple carburetor to take out takes about 5 minutes to pull the 2 clamps off. You don't even have to take the carburetor completely off the quad with t. Throttle or the choke lever, you can leave that on there and just clean it out with welding, a brazing tip cleaner. I'm just not getting any fuel into the carburetor at all. That was as of this morning but I will maybe post a youtube video on this
@brydancorporation79872 жыл бұрын
Keep that running for my visit... whenever that might be!
@garagestory2 жыл бұрын
Sounds like a plan!
@sovereignfalcon11192 жыл бұрын
Thanks for sharing!
@garagestory2 жыл бұрын
My pleasure! There should be more atv content coming up.
@TheChronicsmokaАй бұрын
Where does the inlet tube going to the air box go?
@garagestoryАй бұрын
It goes up by all the range controls levers above the gas tank. It’s basically a snorkel.
@mr.courtney5703 Жыл бұрын
👏🏻👏🏻👏🏻👏🏻👏🏻👍👍
@francois930 Жыл бұрын
I like your video . I have a Question . the bike run well when not moving . But if i want move and run little faster the bike be funky run as lagy Like if are sinking because the gaz sinking and sparking . gaz are news cabuartor are clean is out from garage i have to put in choke and filter airs detached . I think i need put new caburator Do i ?
@garagestory Жыл бұрын
I’m not sure what the problem would be. Mine is kind of acting like that now, but I haven’t made time yet to work on it again. It might be the fuel pump.
@francois930 Жыл бұрын
@garagestory I found it and fixed little is the caburator float . pointy . the float need adjutement . and is acte little better . I have buy other caburator . but the old one will old for 5 month ^_^