Thanks 🙂 it's great to be back

Cheers 🍻

Thanks Denis, it's great to be back 🙂

Thank you very much it's great to be back 🙂

Thanks Mark 🙂

Thanks Samuel it's great to get back 🙂

Thanks Wayne, it's good to be back 🙂

Thank you 🙂

Thanks Patrick 🙂

Thanks 🙂

Thank you its good to be back 🙂

Thanks Thomas, yes doing well now 👍.

Thank you very much, It's great to be back trust me I was worried myself too 🙂

Thanks really appreciate that, I might take you up on that offer when the time comes 🙂

Thanks, it's good to be back 🙂

Thanks William 🙂, fingers crossed its sooner rather than later

Thanks William, it's great to be back 😀

Haha 🤣 thanks Brendan 🙂

Thanks very much John 🙂

Thanks Andrew it's great to be back 😀

Thanks Denis 🙂, maybe just maybe you need to knock the walls and show herself the door 🤣🤣

Thanks very much 🙂 more to come on the cnc too

Thanks James 🙂

Thanks Joe it's great to be back 😀

Thank you very much 🙂

Thanks Paul 🙂 hopefully you are right

Thanks Martin, it's good to be back 🙂

Thank you very much and welcome to the channel 🙂

Oh dear that's not good, hopefully it's just a setback and not an end

@ thanks Tommy

Thanks, it's great to be back and getting into the swing of making videos again 🙂

Thank you very much 🙂

Thanks very much 🙂. Now that is the million dollar question I think a little diesel heater would raise the temperature in a workshop that size but how hot it would get I'm not sure. The cnc room I'm heating is 16x16 and it has no problem would be even better if there was some insulation. I would think on max setting it would heat that size but would use more diesel. I used to heat the main workshop years ago with a big kerosene heater which cost a fortune to buy and run. I guess it depends on how hot you want it and how much do you want to spend buying and running a heater