Impression of Baja Ron Sway bar on Spyder RT Limited

No video

Impression of Baja Ron Sway bar on Spyder RT Limited

Рет қаралды 4,095

2 жыл бұрын

In this video, I discuss installing the Baja Ron performance Sway bar.
I discussed my struggles installing the Sway bar, mostly because I did not have enough ground clearance.
Once I sorted out the group Clearance, the rest of the installation was a breeze.
I think that the sway is a great buy.
The front end feels more planted.
The steering input is more precise.
The bike feels a bit more solid in the turning events.
Tools I used:
10 MM Wrench/socket set
13 MM wrench/socket set
Flat head screw drive for removing the push pins
Torgue 30 bit for removing the plastic bits from the frontend.
Jack for lifting the Cam AM.
Note: You will need at least 24 inches of ground clearance to be able to remove the Sway bar.
#CANAM
#BAJARON
#RTLimited
#Spyder
#canamspyderaccessories.com
#pierre
I purchased the sway bar from:
www.canamspyderaccessories.com/
Installation video:
• Part 1 of 2 - Installa...
• Part 2 of 2 - Installa...
Donations:
cashapp: $SebFort
Please Share, Like and Subscribe to my Channel.
Please add your comment and let me know what you would like to see on the channel.

Пікірлер: 11

@gregfaucher6338 Ай бұрын

Great video but why the background music. I know a lot of people do that but why add it. I’m not knocking you I’m just curious.

@Brute750 Жыл бұрын

Great video and solution to your lift issue. Hope alls well with you. Hope to see more videos from you and update on what’s been going on with you these past eight months. Take care.

@billwilliams9527 2 жыл бұрын

Good job Sebastion, getting creative with that extra 2" or so, saved you some $. Glad Baha Rons sway bar worked out.

@SebastianFortune 2 жыл бұрын

Thank you Bill. :-)

@zouari95 2 жыл бұрын

Hi there I have I boasted my RT LIMITED SPYDER 2020 After winter storage in my garage it worked for 20 min the start bibinig and show in the left screen (VSS FAULT) TOO MANY TIMES AND MODE ..... THEN Stopped working I don't understand what is going any help or suggestion thanks

@SebastianFortune 2 жыл бұрын

Hi there Majdi. I have not experienced this issue before.

@zouari95 2 жыл бұрын

@@SebastianFortune thanks anyway

@Den-nu6pv 2 жыл бұрын

Aw that sucks 😞 you said your jack was 16 inch's and that you needed 24 inch's well that board you used was only 2 inch's putting you at 18 inch's height all together and that seemed to work unless I'm missing something.

@SebastianFortune 2 жыл бұрын

What Sucks Den? I like the Sway bar.

@billryan8707 2 ай бұрын

@@SebastianFortune This Den fellow asked a valid question if you had 16 and added a 2 inch board you would still be 6 inch’s away from the 24 inch clearance Sebastian why did you not explain Thanks Bill🇨🇦👨🏻‍🦳