I'm actually about to replace the stuffing tube and run it under the tub. I know that's what it is. I actually took it out today for a quick test. I moved the turn fin back to where my cg is and she was running pretty good. Still has a little bounce at lower speeds. Thanks for watching.

Uuyy

Yyuuuy 😝 KZfaq yuyyyy

Yuu

Y

That was a perfect flip. Oh man couldn't do that again if I tried. 😆

The atomic catamaran? How did the atomic preform? GOOD LUCK with your build.

@@IRONCLADRC I can't speak from knowledge or experience because I'm new but I REALLY like the Atomic catamaran. One reason I purchased these two boats was to learn and experience some of the differences between them. The FT012 is a V hull and it has trim tabs and stabilizers on the rear. The Atomic is a catamaran without trim tabs and stabilizers. To my surprise the catamaran handles WAY better without the extra hardware the FT012 has. The Atomic got up on plane quicker and it turns on a dime! I guess it's the difference in the hull design? I paid $130 for the Atomic and couldn't be happier.

Wow that's awesome 👌

Sounds about right look on ebay for that motor they usually list the pattern size

I wouldn't say it doesn't need programming It can be programed using your remote control

You more than likely have the boat "over propped for that speed control, maybe try going down in prop size to reduce load? Could also be the low voltage cut off letting you know to bring the boat in and Change batteries

The new v2 shark is a better choice, the v1 shark was better than the hobbywing

What's the length of the boat? Is it heavy for its size or light?

An tfl SSS brushless motor is a great upgrade

It will work If you can waterproof it?

2835 burned on 3s with a prop that was to big for the motor. The 2835 actually handled 4s with a small prop under light loads.

www.offshoreelectrics.com/proddetail.php?prod=ose-80080-c

Plug the 2 middle wires together the 2 outside wires don't really matter which one you plug in to one another. The 2 outside wires change the motor direction. Hope this helps

@@IRONCLADRC Errm so two out side wires are red/black and middle wire is signal then yeah ? Think that’s wot I’m getting from your reply ? As you mentioned 2 middle wires and 2 outside but there’s only 3 in total

Yep. Never seen that one before.. she's got potential for sure

Offshoreelectrics.com has leopard outrunner motors I think there 6s. Aquastar has an outrunner motor as well, hard to find!

www.google.com/shopping/product/1/image?q=trex450+upgrade+motor&client=ms-android-uscellular-us-revc&biw=360&bih=672&sxsrf=ALeKk02qPjw9qFC0Yp_tq1DXnEna2vGtqA:1628119479506&sa=X&ved=0ahUKEwj9_f3ywZjyAhVhRzABHQyzBFgQnUAIQQ&prds=cs%3A1%2Ceto%3A17001821010392615322_0%2Cpid%3A17001821010392615322%2Csgro%3Aiv%2Cmvi%3A0

Racerstar 2235 4000kv

@@IRONCLADRC 2835 4000kv ,must be re labled ,run 4s my goodness 😊

Yea I looks tobe the same like u said just rebranded or something.

@@IRONCLADRC 👍..can you do a destruction test on one of your motors like set it up in a mount and give it full revs until it blows or not,I bet the Outrunner lasts longer as it cools itself

I ran the rocket 2968 4000kv with a dynimite 30a and the Temps were warm/hot