Jason Sack's Cowboy Up Nova Gets Steve Morris Engine's SML

Jason Sack's Cowboy Up Nova Gets Steve Morris Engine's SML - Part 1

Рет қаралды 10,925

11 ай бұрын

Jason Sack's Cowboy Up Nova was already a formidable drag-and-drive streetcar capable of 200 mph 7-second quarter mile ETs and 2,200 horsepower. However, the quest for more power and performance is never done, and that's where Steve Morris Engines comes in and the new SML engine platform. Watch as Steve readies an SML for Jason's car to debut at Drag Week 2023.
#engines #enginebuild #enginebuilding #turbo #turbocharged #machining #chevy #ls #dragracing #draganddrive #dragweek #horsepower #performance #enginebuildermag
www.enginebuildermag.com/
www.stevemorrisengines.com/

Пікірлер: 15

@scotthultin7769 10 ай бұрын

229👍's up Steve Morris thank you for sharing 😊

@Ron_Masterjohn 11 ай бұрын

❤ Dewey ❤ gorgeous block by the best in the business.

@junkyardjunkie7192 11 ай бұрын

When you were talking about the aluminum main You took the words out of my mouth. I was thinking about the expansion rates.

@scottellerman1976 11 ай бұрын

Steve you kill me with the high pitched... "whaaaaaa"! I would do the same thing!!

@rikiwakwak 11 ай бұрын

The water jacketing alone, is as good of an upgrade as every other aspect. Artistry

@junkyardjunkie7192 11 ай бұрын

I swear everything sme does is artistry😮😮mind blowing

@TheUn-namedProject 11 ай бұрын

Steve my man, I would love to see you measure the before and after of the sleeve with nitrogen. So cool.

@jtg2737 11 ай бұрын

First out of Texas!

@roysebastien4598 11 ай бұрын

its easy to machine the spot face on the side with a horizontal mill

@glenbrannon7224 11 ай бұрын

Nothing like fine jewelry!

@Calvin-xp4qp 11 ай бұрын

15:29 🤣

@georgedreisch2662 11 ай бұрын

Pretty sure the word Steve was looking for, when cutting the main bearing thrust face, is, interpolating…

@mcintyretyler89 11 ай бұрын

Could a feller put one in Santa's sleigh for me please.

@WDMtea 11 ай бұрын

Deja Vu???

@craigmooney2630 11 ай бұрын

Ounce Toms team gets on top of the machining you’ll be looking good, it took Bullet engineering in Australia awhile to get it right