Rob and Chris explain how to use the Auto Calibration software for a JVC DILA, focusing on the new models DLA-NP5, DLA-NZ7, DLA-NZ8, DLA-NZ9, DLA-RS1100, DLA-RS2100, DLA-RS3100 & DLA-RS410O.
Пікірлер: 18
@sumdaddy27 Жыл бұрын
This a very helpful video…just got my NZ8 and I ad a couple of questions…. 1. Does it matter if low latency is on? Which if preferred, on or off when calibrating? 2. Motion enhance should be on off/low/high when calibrating? Or does it even matter? Any help would be appreciative
@petertan730015 күн бұрын
Hi please advise the projector NZ8 do not display password line for me to set the similar password setting on the laptop ? Thank you
@darthsquider8586 Жыл бұрын
When you do second, third or later calibrations in the future, do you reload the INIT file first or can you just calibrate from your current calibrated settings?
@michelegrassi3492 Жыл бұрын
please enable subtitles, many thanks
@ollifz31309 ай бұрын
Is the new Spyder X2 elite or ultra working with the calibration software? If yes, is there any advance in using the new Spyder?
@calebpriester89086 ай бұрын
Does HDR10+ need a separate calibration from HDR10? Just want to be sure I got everything done right!
@gregorystevens5173 Жыл бұрын
Should we be feeding content when calibrating?
@shadowfallenable Жыл бұрын
Many youtubers say that gama 2.2 is in the past. The accurate setting is 2.4. Is it true?
@MrPninja11 ай бұрын
After calibration and I turn the projector and back on all the calibration is gone
@topostornottopost3371 Жыл бұрын
Hey mine doesn’t have the input for password in the network setting
@TerminatorJuice Жыл бұрын
You don't have a NZ series or NP5 projector do you?
@topostornottopost3371 Жыл бұрын
@@TerminatorJuice correct
@topostornottopost3371 Жыл бұрын
I figured it all out
@petertan730015 күн бұрын
@@topostornottopost3371 hi can you advise how you got it figured out as I face the same issue thank you
@user-rb6nf1mp4v3 күн бұрын
Video is false the software claims that it can’t find any sensors
@lage53 Жыл бұрын
YOU ARE WRONG? The light receiver faces the projector and not the screen, if you use Spyder optical sensor. In instruction manual JVC refere: "Install the optical sensor. Adjust the position of the sensor such that it is within the range indicated in orange on the software as show in the figure on the right. If you are using Spyder, install the sensor between the projector and the screen with its light receiver facing the projector".
@mr2cqql Жыл бұрын
Yes, for the older version spyder 5 you face the projector. But for spyder X you face the screen instead.
@lage53 Жыл бұрын
@@mr2cqql thank you I was using calibration software11 and now I use calibration software12