Great video. Unlike a lot of these self help videos, where they talk a lot of smack for 3/4 of the video, this is to the point
@thejoseandresshow9 жыл бұрын
The rubber that seals the hole in the cap comes with the kit?
@KINGAZHAR78785 жыл бұрын
Superb bro
@Retrofitlab5 жыл бұрын
Thanks!
@kanalteknik45895 жыл бұрын
Good Job bro 👍👍
@luismatos79819 жыл бұрын
Muchas gracias.
@ManzurGuzman7 жыл бұрын
Can you change the bulb if it goes bad later? Or you have to take the headlight apart?
@ehhhh74 жыл бұрын
Hi, super work. Please, tell me 2:53 rubber's (or glue) name. How can İ find it?
@Retrofitlab4 жыл бұрын
Special headlight butyl :-) www.retrofitlab.com/en/butyl-rubber-sealant.html
@ehhhh74 жыл бұрын
@@Retrofitlab thanks 😏
@luismatos79819 жыл бұрын
Hello as I do to install the lights in the angel kia k5 that was what I wanted to know
@blackfrediegeorge9 жыл бұрын
Nice guys keep it up
@DoggMan.Official4 жыл бұрын
pls co to je za lepeni v minute 3:07 to je silikon ? nebo lepidlo ?
@Retrofitlab4 жыл бұрын
Jedná se o speciální butylové světlomety, speciálně používané pro těsnění světlometů. www.retrofitlab.com/en/accessories/butyl-rubber-sealant.html
@damaged_merchandise7497 Жыл бұрын
Love the work🔥🔥 what’s that sort of silicone you applied between the headlight clear lens cover and rear cover?
@Retrofitlab Жыл бұрын
This is a butyl sealing: retrofitlab.com/products/butyl-rubber-sealant?_pos=1&_sid=8f8d38087&_ss=r
@ariskeram57704 жыл бұрын
Need a kit like that for a Nissan N15 model...
@Retrofitlab4 жыл бұрын
Sorry, no specific kit for it. Probably the Mini H1 with the mini gatlin shroud would fit :)
@LAZER-PALDZOR3 жыл бұрын
How to avoid moisture i did it on my headlight installed drl but one headlight started absorbing moisture do i have to reopen and do it
@Retrofitlab3 жыл бұрын
Using butyl to seal it / a good seal is most important. But it also needs to ventilate, with these vents you can optimize the ventilation (to let the damp air out). www.retrofitlab.com/breathing-vents.html
@Dzdoctors8 жыл бұрын
do you bi xenon and angel eye for kia picanto morning?
@mehmetsenabaglan18067 ай бұрын
Kia joice sol ön far sol arka stop lambası lazim bana varsa cikma veya sifir
@faisalstoriesno17 жыл бұрын
size of angel eye?
@phildeleeuw89148 жыл бұрын
Ziet er niet super moeilijk uit.. Maar hoe groot is de kans dat die lek gaat? Als je dit zelf doet kost veel meer tijd dan laat doen..
@phildeleeuw89148 жыл бұрын
+Retrofitlab begrijp ik. Heb via Ali express drl verlichting gezien. Heb een Astra h met "angel eyes" zonder drl en gewoon 4 ledjes per oog. Enige min punt is. Dat enkele ledjes binnen 3-4 maanden doorbranden. En elk jaar met apk open moet doen. Ben er klaar mee 😁. Dacht dat zo'n vervanging te doen moet zijn..
@r-deeess50549 жыл бұрын
Does opening the headlight case will cause a moisture? Thanks!
@r-deeess50549 жыл бұрын
***** Thanks u failed to seal it properly:) Just kidding, i mean thanks for the answer. I know u did it well.
@superfill755 жыл бұрын
15 minuti di tempo per far riscaldare il faro per aprirlo, ma a quanti gradi?....80°,100°,150° quindi, 15 minuti per gradi...? grazie
@Retrofitlab5 жыл бұрын
Preheat the oven at 200 degrees Celsius. When ready, switch off the oven and place the headlight inside. Make sure that the headlight is not touching any metal of the oven by placing a cloth over the grid, for example. Leave the headlight in the oven for 10-15 minutes before opening it. If the headlight kit is not yet soft enough, put the headlight in the oven for a bit more time.
@MidianRenovatio5 жыл бұрын
What is the kind of 'glue' or silicone that you use, please? I would like to do the same with my seat ibiza cupra 2002. Best regards.
@Retrofitlab5 жыл бұрын
We use special headlight butyl; www.retrofitlab.com/en/butyl-rubber-sealant.html
@marciohenriques5979 жыл бұрын
GOOD JOB WOULD YOU LIKE TO SEE IN THE LIGHTHOUSE MEGANE GRANDTOUR HOW WOULD . THANK YOU .
@marciohenriques5979 жыл бұрын
ok
@hadam965 жыл бұрын
Could you tell what heat setting are you using for heating the box?
@Retrofitlab5 жыл бұрын
e use a setting of 300 Degrees Celsius for 12-18 minutes / 1st lowest setting, depending on the size of the headlight.
@hadam965 жыл бұрын
@@Retrofitlab Thx a lot!, what about angel eyes, they are known to have short life, do you know how to prevent them from burning out?
@Retrofitlab5 жыл бұрын
@@hadam96 Usually with good quality LED ones there are not a lot of problems. Sometimes the driver fail, but they are usually easy to replace and under warranty.
@199106020118 жыл бұрын
what is the exact name of the glue you use to re-stick the headlight
@199106020118 жыл бұрын
thanks a lot because every time i wash my car water seeps into my headlight causing them to fog up i hope this sealant is close to the factory one. And do u have any idea how to remove the old sealant
@ale_amestegui6 жыл бұрын
para un kia rio 2016 sedan que me aconsejan ? usa bulbo H4
@Retrofitlabcom6 жыл бұрын
I would suggest to use the Mini H1 Twin Kit: www.retrofitlab.com/en/hid-projector-kit/bi-xenon-mini-h1-twin-kit-1.html
@luismatos79819 жыл бұрын
How i install in k5 angel light led
@xee19855 жыл бұрын
How do you align the projectors
@Retrofitlab5 жыл бұрын
Make sure to mark the cut-off of the stock halogen headlights on a wall, before you install the projectors.
@blucarter50575 жыл бұрын
Can this fit on my 2013 Nissan note ?
@Retrofitlab5 жыл бұрын
Yes, this is possible! :)
@yunielsevilamendez12297 жыл бұрын
You are the best. do you bi xenon and angel eye for kia spectra 2009?
Hi I have a Mitsubishi Magna 2003 I want to ride lenses of any type installed
@user-lg9dx1dx8w7 жыл бұрын
Thank you
@thumuaienthoaicuhongtv96946 жыл бұрын
Why mori ❓❓
@Retrofitlab6 жыл бұрын
?? What do you mean :)
@jinzheng53473 жыл бұрын
I am the manufacturer of car lights from china , our main product is LED&Laser projector for car lighting upgrade and also customize the lighting based on your requst. if you are intereted I can send you more infromation about laser projector , I believe our laser projector can sell well.may I have chance to do business with you