Kreg Cabinet hardware jig

Рет қаралды 14,512

3 жыл бұрын

In this video I show you how to use a simple Jig to save time when drilling holes for cabinet handles
Here is a link to buy the Jig
amzn.to/2SD2xFw
As an Amazon Associate I earn from qualifying purchases.

Пікірлер: 15

@999gothchick Жыл бұрын

Hi from the uk 🇬🇧 I have bought this tool and the cabinet door jig as I’m upgrading my kitchen and putting new doors on my cabinets, the kreg tools are well worth the money and have made it so much easier so I can change them all without help 👍🏻

@mdouglas2814 2 жыл бұрын

Dude I got motion sickness watching your video

@fantoms58 2 жыл бұрын

Thanks for making this. I got the last jig on Amazon and looking forward to putting my hardware on.

@A2Z1Two3 3 ай бұрын

I just leveled up a drill bit on my drill ,then taped a small level to the top of my drill and kept the bubble in the lines . My handles were Cup handles , so precision is critical asa tiny error over that smzll pitch makes them look squint to the eye .

@debbieashment7847 3 жыл бұрын

Good looking cabinet job and handles!!!

@PilotJon 3 жыл бұрын

Thanks Mom :)

@betoxyz68 Жыл бұрын

Thx for the tips!

@don.kowalski 4 ай бұрын

thanks for the video, very hard to follow as camera was all over the place.

@MarianaEmiliaDioly 3 жыл бұрын

Wow! Good Job, Jon! I liked this blue tool, we don't have this one in Brazil, well, I never saw one. 🤔

@keithstadler8694 Жыл бұрын

Good work. How did you line up all the handles for the drawers though as must have been hard to get them all lined up vertically?

@victortrujillo2591 Жыл бұрын

What type of wood did you used to make your kitchen cabinets? Thanks for sharing your knowledge!!

@PilotJon Жыл бұрын

Thank you! The frames and faces are alder

@A2Z1Two3 3 ай бұрын

I also measured in metric as its much easier ( even though I was taught in imperial)

@Jaysen6740 3 ай бұрын

Would it not be easier to do a pilot hole first?

@A2Z1Two3 3 ай бұрын

Not really , as the hole in the jig is so large , a smaller drill may not find the exact centre , and when you use the correct drill it could catch the off centre hole and drag it off centre damaging the metal ferrule in the jig .