KUKIRIN G3PRO - Introduction P Settings - Speedhack- Zero Start

KUKIRIN G3PRO - Introduction P Settings - Speedhack- Zero Start - Cruise Control

Рет қаралды 28,238

Жыл бұрын

Rain, Book And Cup Of Tea by | e s c p | escp-music.bandcamp.com
Music promoted by www.free-stock-music.com
Attribution 4.0 International (CC BY 4.0)
creativecommons.org/licenses/...

Пікірлер: 36

@itaco8066 2 ай бұрын

Great video Thank you!

@Natsukashii1111 Жыл бұрын

thanks a lot for this video, my G3pro came by default with PA at 5 and I didn't know that so it was way too powerfull. Tonning it down helped me appreciate it a lot more!

@SYTROP14N Жыл бұрын

That's correct my is also preset to 5, way too powerful for two motors, each start its almost spin the wheels, now set to 1 and is where it supposed to be.

@JohnOLooney 9 ай бұрын

@@SYTROP14N same here , mine was set at 5 , its way to harsh, i set mine to 1

@iphone-repair-fuengirola Жыл бұрын

Good video

@ua2924 Жыл бұрын

Hello! Please tell me, is there a recovery on Kugoo Kirin G3 Pro?

@otakarlibal Жыл бұрын

Thanks for the video! Is there any way to keep the full power and full speed, but just improve the throttle response. It is way too sensitive. It feels like you go from 0 to 15% throttle and nothing happens, then you go from 15 to 16% it jerks forward and gives you like 70% and then the remaining 17 to 100% throttle just moves you from like 70% engine power to a 100%. If there is any way to make it linear and easier to control i would really appreciate

@JohnOLooney 9 ай бұрын

the throttle is adjustable in the parameter settings , its set at 5 by default, toggle it down to 1 is my advice - its jsut too spicey bny default and youll pull your arms off

@faridskafee5392 5 ай бұрын

I just want this monster to run without pushing. Help me with that through the settings

@kendallleary9991 Жыл бұрын

Once driving how do you activate cruise control

@ricobico1872 Жыл бұрын

It does it automatically....do not recommend....

@Prodigee1979 8 ай бұрын

Why you want to leave Pb off (0) ? It's the E-brake strength and it's very important to have it ON if you want to brake/stop fast. If it's on 0 you will only use the normal brakes (front and back) and will have to buy new brakes too often, the e-brake is really important!

@clementevillalobos345 6 ай бұрын

The ebrake on this is way too powerful and unsafe. I barely squeeze the brake lever and it locks the brakes almost throwing me off. I have it set at 1 the minimum too. I don't like. Its very dangerous when front brake engage. The stopping is way too abrupt for normal riding around 15 mph. It's unfortunate it can't be set to activate at higher speeds. I might disconnect the electronic if I continue to experience this problem. I just feel safer in braking. The hydraulic alone suits me just fine. Light riders be aware of this problem.

@ladehier 4 күн бұрын

if the battery is full and your first drive are down hill mean you drive from a mountain down then possible also your battery get damaged. some battery have this problem. also you are right with other arguments.

@octavioborda3767 Жыл бұрын

p07 work for only 1 of the 2 motors . so impossible de control speed on second motor …. useless

@ladehier 10 ай бұрын

Yes you are right. But the price is really ok.

@abbiesekoum2249 10 ай бұрын

What is the PA about ?

@JohnOLooney 9 ай бұрын

acceleration

@alexanderthegreatest5336 Жыл бұрын

My G3 has a speed issue, it doesn't go faster than 15mph though i switch to mode 2 or 3, still same speed. Who can help me out?

@ricobico1872 Жыл бұрын

Go to setting PO7....Set it to 100....Long press

@deijannoreiga3924 Жыл бұрын

@@ricobico1872mine is set to 100 and is still doing that

@SYTROP14N Жыл бұрын

P7 is useless. I've set 33 as P7 value, and 2nd gear two engines still goes to 45km/h but 3rd gear is limited to around 35km/h. xD

@ggale1 Жыл бұрын

PB Not work. Why?

@linqu69 Жыл бұрын

I’d like to know that too, on the manual it says it would work, that would be important to work, without it brake pads wear out quickly.

@robertcseh4619 11 ай бұрын

My Pb brake is also not working

@robertcseh4619 11 ай бұрын

Who know what will be the problem please.

@Prodigee1979 8 ай бұрын

Set it to 5 or 4 then you feel it.

@Nutrient16 Жыл бұрын

This doesn't work for M5 pro

@ladehier Жыл бұрын

Ok let me try out byself. Our tean was sick last 2 weeks. Let me come back to you with good news ;)

@maximljubavin9156 Жыл бұрын

Thank you we are waiting

@JohnOLooney 9 ай бұрын

this is for the G3 pro, why would it work on a M5 Pro ?

@savas0012 Жыл бұрын

This doesn’t work for m5 pro

@ladehier 10 ай бұрын

its an G3 Pro. not all scooter have same functions and also not same way how to come inside the hidden settings

@alexandresquare 9 ай бұрын

same, but you still have part of the settings like cruise controll