Рет қаралды 185
The unit is programmed, we build a new control panel, and finally, we have to run the machine and actually cut material to test it out.
If you don't want to watch the whole thing, or you just want to see a section over again, just use the menu below.
00:14 - Gimp Photo Editing
02:53 - Inkscape Button Creation
04:22 - Example pyVCP code
04:31 - Showing the pyvcp Panel
06:06 - Testing the machine
07:51 - Homing the machine
09:47 - Starting a test cut
11:12 - Running the job at a deeper cut
12:49 - Closeup of the finished cut
13:07 - Electronics Layout