Yeah for sure! I actually don't know how to send a photo through to you with my sketches with the measurements, but here are just the measurements of everything. 4 pieces coming off of the frame 11.5"L 4" W (inside two I cut at a 45 degree angle so i could have the front angle piece) Winch base plate 12" L 31" W (I cut out squares on each side so it can slide as far back to where the frame comes out as possible) side triangles: 19.5" L 4.65 down to 2.5" at the ends 20 degree angle back to the rover fairlead front 11.75"L 6.5" down to 4.65" front sides 9.5"L 4.65W and I boxed/gusseted it in but I just cut to fit those. Will try and see if I can upload a picture with all of this to the channel so it makes more sense! Cheers, CE