Thank you so much for watching. If you are looking for a more comprehensive straightforward shelf install check out this video: kzfaq.info/get/bejne/jrmdpZyH1r7en5s.html
@Samcraftcom3 жыл бұрын
Those shelves aren't going anywhere, super strong!
@LandtoHouse3 жыл бұрын
These are definitely strong. I am gonna be putting about 1600 pounds on there so still going to put the front support. I would hate the studs to come out.
@JoeMalovich3 жыл бұрын
Very cool! Certainly seems stiff enough.
@jamess17873 жыл бұрын
Yes, this. Just have to figure out how to get a waterwheel installed on it :D
@robdembski56483 жыл бұрын
Nice simple shelving that should be plenty strong. Small suggestion, though... You could have picked up a chalk line at the hardware store and used it to snap a level line across the wall at your first pencil mark on the stud. Then you wouldn't have had to play the balancing act with your level, support triangle, and impact driver since that reference line would be transferred to every stud.
@nintendolunchbox3 жыл бұрын
Congrats on the promotion. Hey man. I bet you felt a bit daunted when you bought your first property or land. I know I did. It’s always a good thing.
@jllaine3 жыл бұрын
Love the videos my friend. Just to your right as you are using the compound miter saw to cut the diagonals of the triangles for the shelves, is a hold down clamp to secure your work piece instead of having to use a scrap on the left. Hanging the supports, attach the first stud inside triangle, hold up the last stud inside triangle and a 2x4 across them. With a level across the 2x4 will set your shelf brackets level. Leave the 2x4 sitting on top of these 2 triangles and you now have a stop/alignment block for installing all the other triangles.
@LandtoHouse3 жыл бұрын
Thanks! That clamp on the saw hits the motor on these really close cuts. So I have to use a scrap to hold those. I really like the 2x4 idea. I might have to do that today as I make more shelves.
@jllaine3 жыл бұрын
@@LandtoHouse Glad you like the 2x4 idea and moving that clamp to the left side and cutting on the other 45° eliminated the motor/clamp interference (I have one of those saws)
@TheVonhollan3 жыл бұрын
i would have done the two ends of shelf first then used a board between the ends. so all you have to do is get them to your board
@Paulie12323 жыл бұрын
Its looking good
@LandtoHouse3 жыл бұрын
Think you. I need to finish all the others so I can get my boxes in. Yes I had a certain cold that was very common in ....2020. Lasted for about 2 weeks.
@Paulie12323 жыл бұрын
@@LandtoHouse thank god it wasn't COVID
@LandtoHouse3 жыл бұрын
🥶 I got that. Actually my whole family got it. For me it was not bad. For my mom it lasted over 1 month.
@slav7773 жыл бұрын
Good afternoon, what kind of wood do you most often work with?
@LandtoHouse3 жыл бұрын
This is spruce. Or pine. We have lots of this in my area.
@slav7773 жыл бұрын
@@LandtoHouse And pine is generally a very soft breed, if you make a computer desk out of it, right?