In this video, I demonstrate how to engrave on a metal ammo can on a Aeon Mira 9 laser. Any laser that has a Z axis deeper than 6" will work. I include settings in the video. / hustleandburn
Пікірлер: 20
@markcox3023 жыл бұрын
Great video! Thank you for sharing it!
@loriwilliams2393 Жыл бұрын
Amazing video very very helpful, Thank You so much
@allenyarberry7502 Жыл бұрын
Well done on the video!
@computercreationz2 жыл бұрын
I enjoyed the video thank you!
@CandyKemp Жыл бұрын
Thank you so much for the video. Where do you purchase your ammo cans from?
@romualdosalinas86792 жыл бұрын
Awesome! TY question can a Mira 7 do this.
@zangranillo9536 Жыл бұрын
What dilution did you use for the LA totally awesome?
@user-zq6pj5jo8j7 ай бұрын
Can you show what this looks like on your Thunder Laser? What power and settings you use ETC..? Thank You..:)
@jimwood4332 Жыл бұрын
when you get done can you feel different level of the paint ? Thanks
@roger-roger_975 ай бұрын
Nice. Where do you get the cans from?
@suremike2 жыл бұрын
Do you have a website from which I could order a custom engraved Ammo can?
@billieb Жыл бұрын
Wow. I would love the Thunder and would love to see hubbys face when I tell him I am putting it in the dining room. I have to ask, what is your biz that you can afford two of the babies?
@craigthompson65152 жыл бұрын
Have you had any problems with the engraving not removing stains on the raw metal during the engravement? I had some issued of discoloring on the raw metal. Any advise on how to remove the stains. I've tried LA awesome and Zep 505 without luck.
@bobhill1048 Жыл бұрын
LA Awsome and a magic eraser, should do the trick, I don't have any luck with paper towels or rags.
@ussreddawg3 жыл бұрын
Very nice! Where do you get your ammo cans?
@alishapate65503 жыл бұрын
I get them from Harbor Freight or Academy. I don't know if you have those in your area. They typically are sold for around $14.00 each.
@jacquelineappel47753 жыл бұрын
How tall did you make your table? We’re building a table for my 9 now!
@alishapate65503 жыл бұрын
19" and I wouldn't go over that. I see people do that and then they are using stools to get into the laser.LOL
@tylerrogers32 жыл бұрын
Have you tried to engrave any actual gun parts?
@alishapate65502 жыл бұрын
You can only "Mark" a gun and not engrave. You need a Fibre laser for that.