Machine Guide 15 | Camera Calibration on 1030*750mm Working Area

Рет қаралды 569

3 ай бұрын

What can you learn in this video?
1.Instead of framing and move the materials to the right position,throught the camera view,you can precisely put the pattern on the material and preview the finished work.
2.Trace and then engarve will be a much convenient way if you want to do handwriting or trace image on calendar
3.You can engrave on used materials,create some small crafts on it.
4.With Lightburn/Lasergrbl offline function and the camera,you can work offline after you put your materials on and figure out the Z offset.
NEJE Max 4:
neje.shop/products/neje-max-4...
🔗For more products:
neje.shop/
🔗Get NEJE ideas:
nejetool.com/
🔗Join our FB group :
/ neje.shop

Пікірлер: 8

@jasonpecoroni3867 8 күн бұрын

I keep seeing height of 30 cm so I ordered this. My enclosure is 35 cm and the camera will not work at that height. I need around 70cm to get the full bed area. This is with the max 4 750x460mm bed.

@nejestudio686 7 күн бұрын

Hi Jason,may I know if your working bed is 750*460mm and your enclosure is 35cm tall?

@jasonpecoroni3867 6 күн бұрын

@@nejestudio686 750x460mm bed and the top of my enclosure from the honeycomb bed is right at 35 cm.

@nejestudio686 2 күн бұрын

We tested with our 750*460mm bed,the height is around 30cm,it's working good.You can check some youtuber's videos.Try one more time and you will make it!

@prmvera 2 ай бұрын

The the camera is then 85° that you sell on the page for the expanded version of the laser, 1030mm. What's the best camera for the 750x460mm frame???

@nejestudio686 2 ай бұрын

Hi there.You can still use the 85° camera,just make the camera height to be 30cm from the machine bed.Did you test it?

@prmvera 3 ай бұрын

Can you please specify the height of where the camera is?? First you said 30mm then 30cm.. it doesn't show all of my bed 29.5×18.11 inches. What height should the 16mp 85° camera be at??????????

@nejestudio686 3 ай бұрын

We are using the 1030*750 cm working bed as an example,the camera is attached in the top,so the height is about the NEJE frame's height which is around 70 cm.You can make it lower or higher.It's ok,just make sure the camera view can see the entire working bed and then you pass all the calibration test. For 750*460 cm working bed,we suggest the height to be around 30 cm,just as said above,make sure the camera view can see the entire working bed and then you pass all the calibration test.