Follow along as we make two upper arm panels for the NYCCNC Johnny 5 project. provencut.com/ www.nyccnc.com/johnny5/ / @nyccnc
Пікірлер: 9
@MrRedstoner4 жыл бұрын
'We don't need to zero the x because the zero for the x is literally the limit of the machine.' I really enjoyed that one! Too bad you didn't include some footage of modifying the machine.
@HandsonCNC4 жыл бұрын
It was really a bit underwhelming modification.. I observed that there was more throw in the x axis than the limit inductive limit switches were set to, so I took off the block that is used for sensing by the switches and ground it down a bit on either side lol...
@CyberDenSystems4 жыл бұрын
Awsome man!! They look great. Very entertaining to watch the opposite pair being made. Much better audio then my video too. Lol
@HandsonCNC4 жыл бұрын
Thanks.. I run a lav mic into my iphone and record there.. its a cheap way to up the quality of your audio over a camera... And it s not too, too hard to sync..
@CyberDenSystems4 жыл бұрын
@@HandsonCNC I also use a lav with my phone. But for the voice over on the cam part, i still cant seem to get that right.
@joelbennett90144 жыл бұрын
you lied to me there is no johnny 5 here
@HandsonCNC4 жыл бұрын
Its the arm panel... To follow the whole project check out the links in the description for NYCCNC efforts.