The time has finally come. Lots more testing to do but for now it held together. @mistermacgray #mistermacgray #chainsaw #racing Music used Warming Light by Jonny Easton KZfaq link • Beautiful Soft Piano M...
Пікірлер: 15
@markhigby4034Ай бұрын
Awesome video, keep at it you will find the right combination,, she sounds awesome
@michaelwhiteoldtimer7648Ай бұрын
Great that you can bring those old saws back to life
@dmk2632Ай бұрын
Amazing video once again.
@brendosghanasenditsawsАй бұрын
Awww man!!! I’d love to build me one of those😍
@midnightrider1178Ай бұрын
Looking Great!
@jeffreyrubish347Ай бұрын
Looks good!
@user-cs1ko6wr4q9 күн бұрын
Badass saw.
@mistermacgray9 күн бұрын
@@user-cs1ko6wr4q thank you
@cletusschaub4398Ай бұрын
Way kool !!!!
@macandmallАй бұрын
I think your idle circuit is too rich, it is loading up and tricking you into leaning the high speed circuit, that’s why it was stalling in the cut. These engines will settle down into an idle, not slow enough to stop the clutch from engaging, but they will idle. When you get the idle correct, it will respond better too. Those big sprockets tend to throw chains, the drivers are not in the bar groove at the base of the bar. Cool saw you have there
@mistermacgrayАй бұрын
The old pipe it would idle and not spin the chain but with the new pipe it is pulling fuel via proper exhaust pulses. Also I don't want this saw to idle, I want the throttle blade to shut all of the way to kill it as I don't want a run away to happen but it is my primary way to shut it off next to ignition cut. The spark plug is dead on the money for mixture being where it should be. I would rather keep half way safe by nit being able to idle and the chain bit spin vs idling which this saw has no need to sit and idle.