The injectors have been removed and there is air in the fuel system so I need to vent out the high pressure pipes to start up the engine.
Пікірлер: 14
@bendix9983 жыл бұрын
Hi Tino Due to your three fine videos about the injection nozzle removal, checking and refitting, I did the same with my MD2020. So great and instructive videos you do! Thanks a lot. You have made many excellent videos about both the basic and more advanced maintenance of your engine❗️ ...however, in the capital area, I paid 1450 kr/230 $ for the cleaning and checking the opening pressure of the nozzles at a minor Bosch Car Service Center - quite a different price than yours in Randers 😳😄
@bill01182 ай бұрын
Very interesting and useful videos for Volvo Penta owners : I subscribe !
@twiper2 ай бұрын
Thanks :)
@patricklaine69584 жыл бұрын
Three good videos on the injectors Tino. Bravo. I'm sure mine have never been checked/cleaned and my boat is 12 years old. Another item on the 'to do' list. Thanks.
@twiper4 жыл бұрын
Thanks :) - If your exhaust elbow is nice and clean inside I don't think it is necessary to check the injectors, but if you get problems with carbon buildup and reduced waterflow I would check the injectors.
@toms41234 жыл бұрын
Very good tutorials for a beginner with an old MD2020. Me.
@twisterwiper Жыл бұрын
Great instructions! Thank you so much for doing this video. It’s a great help for a novice like me 👍🏻 Subbed.
@jago84134 жыл бұрын
Tino, the Alarm is the voltage. it is to low in the beginning. just give it some more rpm's and it is fine
@alekseimuzychenko17013 жыл бұрын
Thank you for the video. Could you tell what is the modification on the cap of heat exchanger?
@peterihre93734 жыл бұрын
Hur gick det med impellern när du kör utan sjövattenkylningen?
@twiper4 жыл бұрын
The impeller was dismounted at the test run, the cover for the pump was also mounted so the smoke from the exhaust didn't go into the cabin.
@jimduart4 жыл бұрын
Your engine chatters like mine, it was fully reconditioned and I was concerned it had run a bearing , at idle it makes odd clicking noises , any idea why ?