Time saver just take two screws and corner bolt out of fender wells and just reach in and change bulbs or remove lights, no need to remove the bumper and grill.
@andrewmoses26602 жыл бұрын
THANK YOU
@Pitmaster_GoldenShellback3 жыл бұрын
Great video, thank you for putting this together! Helped making the replacement of the fog lamp housing way easier than I thought it would be!
@andrewmoses26602 жыл бұрын
Couldn’t find any other videos on fog light housing replacement. Goated
@freezeseal2 жыл бұрын
Thanks for the video. Wish I saw your video before working to replace my HID bulbs.
@YEMX897 жыл бұрын
Great Video. Yes, going to the dealer can be expensive. I went once for my lights and won't do it again. I own a 2004 TSX, 2007 MDX, and 2010 TSX. The bulb alone they want $198.45. Same bulb on Amazon $50.00 so I brought two and still saved $100.00.
@EndoftheRd5 жыл бұрын
Way to go friend 👍💯
@p1pepper7 жыл бұрын
thanks alot ! found this after removing the screws and clips and was at my wit's end as to how it was attached !
@mikeg30557 жыл бұрын
Thank you... my 2008 had about 6 plastic bolts under the bumper as well that needed to be removed as well as two bolts at the top. The 4 screws were the same. RE: cpaniguams question, there is a way to access from the side of the wheel well if the wheels are turned in on that side to just change the bulbs... It would require removing the bottom bolt and the 2 screws in each wheel well.
@papadank65735 жыл бұрын
Mike G yea, mine has the extra clips bottom as well.
@tomsnyder53244 жыл бұрын
The audio could be louder. Good video.
@dc-gm9tm2 жыл бұрын
Awesome video. Thanks
@frappeboynyc72475 жыл бұрын
Thank you for video.I have no fog lights.How long is the the process of removing front bumper ?Also How does it take to cut and install H.I.D fog lights.?Thank you
@jasmeonce7 жыл бұрын
do you have a video for rear bumper removal for mdx 09
@Tintran27197 жыл бұрын
Very good video. How you get paint for this bumper. Thanks
@hectorgiron18776 жыл бұрын
Great video. I will try it out
@cpaniaguam8 жыл бұрын
Thanks for the video.. if one needs to replace the bulb for the drl only, is it necessary to remove the bumper?
@user-jv4yb3fe5y7 жыл бұрын
No, you don't have to to that to replace the DRL only. I've done it successfully without removing the bumper and trim. Although it's a bit tricky and you'll not be seeing much (as you operate in very tight space).
@Sunny-me1xq7 жыл бұрын
cpaniaguam yeah drl bulb easy to replace from behind the wheel take 10 minutes
@EndoftheRd5 жыл бұрын
Yes I did replace them too but it is tight, believe me.! Because there are two and one of these ( the outers are piece of cake) Good luck everyone 😉
@toddwilliams2543 жыл бұрын
I've done it twice by turning the wheel and opening the inner wheel well fender--and then having my good friend, who has much smaller hands, make the actual swap!! It's pretty tough if you have big hands!
@EndoftheRd4 жыл бұрын
Thank you for your video, yes that’s how we all learned how to get our cars fixed. Again thank you for your help !!
@GAboy30307 жыл бұрын
Im looking for a aftermarket grille without the "beak" for my '16 Acura MDX. Does anyone know of a website that has this?
@AllenManor7 жыл бұрын
good video. How's that MDX holding up for you? Thinking of a 2009.
@EndoftheRd5 жыл бұрын
This vehicles are SUPER my friend, I got a 09 too but make sure the Bluetooth is totally disconnected Acura made them with a malfunction and it drain the battery they never took responsibility in that issue. But all and all these are great vehicles. I love mine ❕💯👍😏
@Sunny-me1xq7 жыл бұрын
Acura dealership would charge you a few hundred just to change that light they are ripped off people I never bring my Mdx back there