Joe - are you using a sliding tablesaw or a cabinet saw?

@@davidbedrosian1567 a sliding table saw

@@joejr.971 hi Joe - adjusting the toe out varies depending on your saw. Higher end models have a built-in mechanism to make minute lateral adjustments to the slider position. My saw doesn't have that so as part of aligning the sliding table height and travel, I also tried to get the toe out close to where I wanted it. I was mostly focusing on getting the sliding table at a constant height so the toe out was secondary. My final toe out adjustments were made by slightly pivoting the position of the cast iron portion of the saw. For me, this was a better approach than trying to laterally adjust the sliding table since I had spent so much time getting it sliding at a constant height and I didn't want to risk changing that. I know that doesn't really tell you how I did it but I hope it gets you started. Are you on Instagram? I've got a number of slider related posts that may interest you. If you search for the tag #bedrosianslidingtablesaw you will find all of my posts.

@@davidbedrosian1567 Thank you so much! I’ll definitely go check out the hashtag, I already follow you on Instagram, but I havn’t searched the tag. Thanks!

Thanks for the comment Robert. With a dial indicator, you don't have to go the full length of the slider to measure the toe-out. In my case, I can see that I have about the right amount of toe-out just by measuring over the diameter of the saw blade. In your comment, you talk about run out which is different than toe-out. Are we talking about the same thing?