Рет қаралды 21,149
In this lecture I explain few methodologies for the fabrication of microfluidic devices. From glass to glass/PDMS to 3D printed microfluidics and single PDMS block. Which one is the best?
researches mentioned in the lecture:
how to make PDMS/Glass microfluidic devices: • Fabrication of PDMS Mi...
Lung on a chip: • Lung on a Chip -- Wyss...
Multi organ on a chip: • Lung on a Chip -- Wyss...
Soft wearable microfluidic device for colorimetric sensing of sweat: stm.sciencemag.org/content/8/...
Soft robotics:
• Rubbery robot fingers ...
• The incredible potenti...
• Soft robot run over by...
The Octobot: • Introducing the Octobot
3D printed microfluidic devices:
pubs.rsc.org/en/content/artic...
pubs.rsc.org/en/content/artic...
iopscience.iop.org/article/10...
iopscience.iop.org/article/10...
ESCARGOT:
• Simple fabrication of ...
onlinelibrary.wiley.com/doi/f...
"thanks" to the 2020 pandemic, part of the course BioNanoTechnology: Sensors & Devices taught at Wageningen University (the Netherlands) was done online.
Please note that these videos are not the whole course, and many things are only mentioned here and discussed further during live lectures.
00:00 Introduction
02:07 Glass Microfluidics
05:24 PDMS-Glass Replica Molding
11:00 PDMS-PDMS Microfluidics
15:26 3D Printed Microfluidics
20:14 Embedded Scaffold Removing Open Technology (ESCARGOT)