WTF!!! I was using headphones and the knocking sound at the very beggining scared me AF. I Thought that someone where knocking at my door o wall! Right now are 1:30am and I am lonely hahaha.
@charleskaylor1493 жыл бұрын
Same here! It freaked me out!
@ThePapapri2 жыл бұрын
Holy cow that’s scary
@bryannunez41812 жыл бұрын
That was unexpected lol 😂
@user-fs5go7fh3h8 ай бұрын
Place the new ring on a wooden block 2 by 4 hold impact on the new ring and hit the back side of impact with rubber mallet the ring is now in place PS a new O ring should be replaced at same time
@mohamadtubless11 ай бұрын
Hi Thanks for this useful video. Can I replace 1/2” anvil with 3/4” one ?
@Gibi19968 ай бұрын
Just with case
@chrisstuffel68193 жыл бұрын
Do you have to split the case just to grease the anvil?
@recklessndalycity Жыл бұрын
I have never had to split anyone's case to lube my anvil, i have split many cases after lubing my anvil
@lacrudarealidad90034 жыл бұрын
a question they send to any part of the world or only in the United States I am from Honduras I hope to answer this comment
@MyScotty73 жыл бұрын
Any part of the world,check out ebay
@ohiooutdoors43322 жыл бұрын
I need one for kobalt 650ft lb impact I can't find it on do you know where I could get one
@EddieSwaggy2 жыл бұрын
Instead of putting 1/2 anvil can you pit 3/8 anvil instead?
@boldbrnd90852 жыл бұрын
Trying to figure out the same thing but 3/8 m12 stubby to 1/2 anvil. Can’t find much
@maxnovakovics25682 жыл бұрын
Could probably get a machine shop to match the anvil diameter and narrow the shank down to 3/8 but to do it with a good tool steel would be pricey. Better off I'd think to find a used or broken unit and just frankenstein it.