To cover the plane I use 25g/m2 glass fiber, normally epoxy resin is used to harden, but I am using a mixture of white glue and 50% acrylic paint because it is much less heavy, the result has been 436g such and as seen in the final images of the video. For the cabin 6 layers of 110gr / m2 and epoxy resin. (Weight included in the 436gr.)

Ehh mira donde te vengo a encontrar! jeje Muy bueno este Zero...

My process is as follows, 1. I paint on the polystyrene with a mixture of acrylic paint and white glue at 50% (we'll call it the mixture). 2. I cover the imperfections and joints with softwood putty. 3. I sand the putty being careful not to remove the mixture. Any excess putty must be removed as it will increase in volume when painted. 4. I always paint again with a roller and cover with 25 g/m2 fibreglass. 5. I paint again with a roller using the mixture. 6. If the putty has absorbed too much paint. A sanding with waterproof sandpaper will even out the surface. 7. Finish paint with the chosen colour. This is much easier than using epoxy, it gives more time for the fibreglass to set. Cleaning can be done with water. And the final weight of the plane is much less. It does not reach the hardness of epoxy, but with less weight the flight is more stable.

@@DepronRCplans what motor did you use in rc and how many volts?

@@kenmiciano811 For this plane the best is a G-46. Required; 60A ESC 4S~5S Li-Po / 12 ~ 16-cell Ni-MH/Ni-Cd 12x8 ~ 14x10 prop bit.ly/3t48oAc

Я покрыл его стеклотканью 25 гр/м2. В этой модели я не использовал эпоксидную смолу. Я провел эксперимент с акриловой краской и клеем ПВА (тот, который используют плотники) на 50%. Положительный результат: значительно легче наносится и меньше конечный вес. Отрицательный результат: прохождение гвоздя оставляет след, хотя общая жесткость приемлема. Andorra

Merci de votre collaboration. J'ai mis à jour le plan, vous le trouverez entre la page 32 et 35.

@@DepronRCplans Génial ! un grand merci à vous !!! vous me facilitez le travail 👍👍👍

Gracias por tu comentario, es fibra de vidrio de 25gr/m2, lo puedes encontrar en tiendas de aeromodelsmo: hobbyking.com/en_us/glass-fiber-cloth-4000x900mm-18g-m2.html?affiliate_code=OEXYOCOFSMYGLKT&_asc=9894889423

drive.google.com/file/d/1DIyGElH5zQpOEWOgfDmMPS8yUA4xBOnZ/view?usp=sharing

You propose me a good project that I will have to consider for the next months.

@@DepronRCplans to wait for your consideration of the F-16