Related discussions on the Bronco forums where others share their thoughts/tips/etc: Bronco6g - www.bronco6g.com/forum/threads/suma-performance-mirrors-review-photos-video---im-impressed.87978/ Bronco Nation - thebronconation.com/accessories-n.136/suma-performance-mirrors---huge-improvement-to-visibility-t.20082/ Reddit - www.reddit.com/r/FordBronco/comments/1ah6whd/dramatically_improved_visibility_suma_performance/
@joelv44954 ай бұрын
Did the exact same swap on a Mercedes Metris I used to own. The USA models in 2016 had a horrid passenger side mirror that felt like looking through a rifle scope. Combine that with zero visibility past the B-pillar and you've got a MASSIVE blind spot. Fortunately the Vito (same model in EU) has convex mirrors; found some on Ebay and did the swap. Dramatic improvement.
@ccorey18311 күн бұрын
I wish my install went that smooth! Ford replaced my passenger side mirror, and apparently also had difficulty with the BLIS plug. Cause it literally just fell apart and I had to repin the connection. On the driver side I just moved the BLIS tabs with needle nose
@BrandonColbyJ6 ай бұрын
Hollywood performance approved
@RagnarKon6 ай бұрын
Oscar worthy performance imo.
@askren766 ай бұрын
Most people don’t adjust their side mirrors correctly. You should not see the side of your car in either of your mirrors from the regular seated position. Properly adjusted mirrors do not require a second mirror unless you are towing. Adjust your mirrors for the blind spot. Plenty of videos on KZfaq that detail this.
@troydavis34923 ай бұрын
I finally received my mirrors today that were ordered first week of February. Seems they no longer provide a trim removal tool
@khalifaalfalasi11663 ай бұрын
Got mine too after a huge delay .. yet i cant understand how to remove the mirror!
@troydavis34923 ай бұрын
@khalifaalfalasi1166 just push on the top of the mirror to tilt it all the way up. Get your fingers behind the bottom of the mirror and just pull it off is all I did. I'm a bit disappointed because the mirror is about 1/8 an inch smaller on all sides than the original, which means it leaves a big gap all the way around and looks ridiculous. Plus the wires have nothing holding them in place, so now they are hanging outside the huge gap. I was going to pull them off to fix the wires but the mirror seems to be weaker than the original and felt as if it would break if I pulled too hard to remove them after they are snapped in all the way.
@AMOffRoad2 ай бұрын
Hi, I like your content. Do you accept sponsored products?
@SeleneSung-x2u28 күн бұрын
Your content is awesome! ! Are you interested in cooperating on related products?
@anthonygallo35766 ай бұрын
Today would have been the day to remove the soft top!
@anthonygallo35766 ай бұрын
Great vid , you need to take a break on bronco accessories and put the money toward rensurfacing that driveway. You cant have that expensive Bronco sitting on that roadmap of a driveway. Keep up the good work
@RagnarKon6 ай бұрын
That’s on the to-do list! Actually saving up to build a garage right now, once that is completed resurfacing the driveway is next on the list. Didn’t want to resurface the driveway only to have it damaged during construction of the garage.
@lgmisfit106 ай бұрын
Except his channel is about the Bronco not about paving driveways