Orifice TAPPING Types and selection | When to use what guide.

Рет қаралды 12,655

Күн бұрын

Orifice flowmeter has various types of tapings.
The most predominantly used tapings are Corner tapping, Flange tapping and Pipe tapping.
In this video you will learn abut how these tapings are derived and when to use which tapings
🔴 Here is the link to receive your free E-book on Engineering PIP Standards
www.asad-shaikh.com/newslette...

Пікірлер: 24

@AsadPassionateEngineer Жыл бұрын

🔴Thanks for watching and if you have liked the Video then you can check out my Master Class on 👉 UDEMY I am highly positive that you would find the Master Class super valuable. Link to Udemy Masterclass : www.udemy.com/course/how-to-read-pids-piping-instrumentation-diagrams-symbols/?couponCode=LOWESTPRICE389 Keep learning and keep growing in your career !!! ✔

@shefalipaul4263 4 ай бұрын

Thanks for sharing valuable information about orifice.

@mdnzm31 2 жыл бұрын

short and sweet , easy to remember,ur videos r Amazing

@AsadPassionateEngineer 2 жыл бұрын

Thank you so much for your kind words of appreciation it means a lot !!!

@buhimanshu Жыл бұрын

I am highly impressed by your knowledge content...keep enlighten us.

@AsadPassionateEngineer Жыл бұрын

So nice of you, thank you for your encouragement and support 😊

@cdiwakareie 2 жыл бұрын

Really worth for all i&c people. Kudos

@AsadPassionateEngineer 2 жыл бұрын

Thank you so much for these kind words of appreciation!!! They really mean a lot to me !!! thanks Chandrababu Diwakar 😊

@uniquesakshi10 2 жыл бұрын

Very well explained.Thanks.

@AsadPassionateEngineer 2 жыл бұрын

Glad it was helpful! 😊

@omkarpawar9178 2 жыл бұрын

Amazing 🤟

@AsadPassionateEngineer Жыл бұрын

Glad you liked it! 😊 thank you so much for the appreciation

@abdessamedghettas7167 Жыл бұрын

Thanks

@AsadPassionateEngineer Жыл бұрын

Most welcome 😊

@abhishekmurarka1984 Жыл бұрын

Nice video

@AsadPassionateEngineer Жыл бұрын

Thank you so much Abhishek !!

@ankurbhatnagar3241 2 жыл бұрын

Good

@AsadPassionateEngineer 2 жыл бұрын

Thank you for your continuous motivation .... It really means a lot Ankur 😊

@prashantdhokiya3767 3 ай бұрын

PIP standard ki book download ka option nahi dikha raha ?

@chinmaycmp 2 жыл бұрын

Would you please share brief on installation guidelines (straight run requirement) for various flowmeters... Or any standard to be referred? There is bit confusion as each Vendor suggest different lengths.

@AsadPassionateEngineer 2 жыл бұрын

For Straight length requirement ISO 5167 is one of the most widely used standards, this standard could be helpful and yes i am planning for a video that cover straight run calculation of orifice flow meter 😊