Outlaw and Outlaw Extreme Transaxle Service Procedure

Рет қаралды 38,183

7 жыл бұрын

In this video we will show you how to change the hydraulic fluid on your 2017 and Prior Outlaw and Outlaw Extreme Bad Boy Mower. These units use the Hydro Gear ZT5400, and ZT4400 transaxles.
For Bad Boy Mower Parts click the link below:
www.badboymowerparts.com/
For Bad Boy Mower Accessories click the link below:
www.badboymowerparts.com/Acce...
For Bad Boy Mower Fast Moving Parts click the link below:
www.badboymowerparts.com/Fast...
For Bad Boy Mower Shop by Part click the link below:
www.badboymowerparts.com/Shop...
For Bad Boy ZT5400 Hydro Service Kit click the link below:
www.badboymowerparts.com/085-...
For Bad Boy ZT4400 Hydro Service Kit click the link below:
www.badboymowerparts.com/085-...
For Bad Boy Hydro Filter 063-1060-00 click the link below:
www.badboymowerparts.com/063-...
For Bad Boy Hydro Filter 063-1070-00 click the link below:
www.badboymowerparts.com/063-...

Пікірлер: 10

@justinrobinson71 2 ай бұрын

This video saved my bacon. Couldn’t find the fill plugs and the half turn screws on the top I thought might be the fill plugs. Thanks!!!

@andrewkeeney701 2 жыл бұрын

Gotta love You Tube and those that create and post videos to help us so much. Thank you. Andy K

@Ford1988ful 5 жыл бұрын

thanks guys it was super easy with your help !! I hope to see more videos about the badboy outlaw👍👍👍

@smitty929929 2 жыл бұрын

Should the lap bars return to the neutral position freely? I have a MZ Magnum 54in deck w/ K740 engine.When pulling bars to the rear position, the bars return to neutral, however when pushing bars full forward the bars do not return completely. Is this normal? Thanks

@Hurst6969 Жыл бұрын

Can someone please advise how to adjust the valves so I can move (not running 2015 Outlaw XP)? There are two vavles on hydraulic pumps but not sure which direction to move them. Thank you!

@robertmlakar7474 Жыл бұрын

On the ZT-4400, does it matter which direction you turn the purge valves 180 degrees?

@6bt_str864 4 жыл бұрын

I would personally have drive wheels off ground minimally to avoid the load weight of machine for first few half dozen back and forth "purging" then once confirmed seem bled THEN put on ground to reconfirm proper noise and engagement . 👍

@rustynail822 3 жыл бұрын

Oil fill vent plug is damn near impossible to access.

@prestonflanders139 3 жыл бұрын

Only problem Is the filter cover is cheap but plastic crap and strips…. And hang up up getting a box end wrench on it with the linkage and framing around to get a good bite. I am highly upset they used suck a cheap PoS cover and stupid design on a 8k mower