Here's a link to the vent cap if you'd like to support the channel, thank you! (Affiliate)

I find it funny how the "EPA caps" meant to stop fuel leaks and vapor escape does everything opposite. Just like everything else from alphabet gunk

Locking EPA fuel spout that spills fuel everywhere... yeah, that's about par for the course with the EPA.

When drilling into thin wall plastic I like to use a jobber (short) drill bit and small cutoff length of 1.5" board (2x2 or 2x4 works fine). You first drill a straight 90 degree hole in the wood so that just a 1/4" or so of the jobber bit sticks out. You can drill a small dimple exactly where you want the hole before using the wood. Then with the wood as a spacer drill your hole, because the wood won't let the bit grab and run up into the plastic you'll get a nice clean hole that won't need work afterwards. My 2 cent tip of the day.

I hate the stupid spouts on the gas cans.

That's how a BOSS opens tamper proof packaging! RESPECT !!!

L O V E the chain saw

Yes you should try it! 👍🏽😀❤️🇺🇸

Do this to those Rotopax containers! Need to see this!

I wonder of that would work in my Rotopax cans? I already swapped over to the h20 spouts on them.

I'm gonna get one those vents for sure!