Support Our Channel : / periscopefilm
This color film about diesel farm tractor maintenance was produced by Standard Oil in the late 40s/early 50s. The time stamps apply to the first mention of the task. It opens with a McCormick-Deering WD-40 diesel tractor, introduced in 1934 (:09). A tractor with a blade fills a ditch (15:19). A special dirt throwing attachment can create terraces (:31). A Ford 8 N tractor (1947-1952) is small for easy maneuvering (:35). A 1940s Case row-crop model (1:42) has a close-up of the temperature gauge shown (2:19). Use clean soft water from a rain barrel in the cooling system (2:37). To prevent freezing, drain and add back water when the tractor is warm (2:50). Some tractors have a pressure cooling system that must cool before removing the radiator cap (3:24). Many have a thermostat that can get damaged (3:47). A fan belt should have movement between pulleys (4:25). The radiator grill on an International Harvester Farmall (4:51) is removed due to overheating from leaves. Air cleaners should be cleared daily (5:32). Once a year, the air cleaner should be removed and completely cleaned (7:25), which includes pouring kerosene through a separating screen (7:46). An extension lets air be taken from a higher level (8:25). The Ford tractor has a cyclone pre-cleaner (8:39). Always inspect the gasket between the air cleaner and carburetor (8:57) for holes, as well as the ventilating tube (10:02) found on some tractors. Inspect the spark plugs and gaps (10:51). The Farmall instruction manual (11:02) provides information for the Farmall H (11:32) plugs and magneto points, as well as the distributor cap (11:55). The magneto is cleaned on a John Deere (12:26). The battery on a Case is serviced (13:00). Manifold regulation (13:48) must also be maintained. The John Deere gets its carburetor adjusted for a rich mixture (14:09); a flow meter (14:13) verifies fuel waste. A Farmall H also has its carburetor adjusted (15:10) before returning to the John Deere again (15:41). Be careful when refueling tractors from free-standing gas tanks (17:50). When cranking a tractor, make sure it’s out of gear (18:07). Some have a starter switch (18:18). Cold operation can affect the oil (18:27). A John Deere gets a new paper oil filter (19:23) and a Farmall gets its oil fill cap area cleaned (19:35) and another gets its valve cover removed to adjust the spark plugs and valves (19:57). An old Farmall with a single wheel at the front (21:02) has its valves ground (21:39). A Farmall H with a mounted bucket pushes hay into the barn (21:59) and can stack it (22:14) using mounted equipment. Tractors get their front-wheel bearings serviced (22:34). A Farmall gets the clutch pilot bearing greased (24:32). A John Deere gets its transmission serviced (25:35). Never tow a tractor (27:02). Hydraulic controls on a Farmall H and John Deere are shown (27:11). If your tractor is left outside, place a tin can over the exhaust stack (27:43). The Standard Oil logo is shown (28:16).
We encourage viewers to add comments and, especially, to provide additional information about our videos by adding a comment! See something interesting? Tell people what it is and what they can see by writing something for example: "01:00:12:00 -- President Roosevelt is seen meeting with Winston Churchill at the Quebec Conference."
This film is part of the Periscope Film LLC archive, one of the largest historic military, transportation, and aviation stock footage collections in the USA. Entirely film backed, this material is available for licensing in 24p HD, 2k and 4k. For more information visit www.PeriscopeFilm.com