Awww thanks 😊

How you have a fryer without safety limits? Yes it is

Not exactly following you but it’s basically a 1 time use brass seal. Once I seat the first screw insert and slide the dollop between the two the second one smashes into the first and uses that as sealant. Sorry if im misunderstanding your Q

@@restaurantrepairs okay so I have to use two of those brass dollops ? When I put that brass dollop on the wire and then insert that into where it’s supposed to go it won’t tighten down so the wire for my gas line to light my oven is still loose. No one else around me can figure this out… sorry if it’s hard to understand this is only video I seen show it. If still don’t understand any possible way to email you so I can maybe provide pictures ? Sorry I have been trying to fix my oven in food truck for over half a year and it’s killing me right now not using it. Small town so no food commercial equipment repair will help me only restaurants.. Thankyou got the reply

Any that doesn’t have digital control board. Generally SG-14 that were electronic ignitions

Thanks for the help!

Do you whatsapp?

Either bad thermopile, bad gas valve, or incorrect wiring. If the pilot lights when you hold the valve but not on its own either the sensor isn’t producing enough millivolts to open the gas valve or the valve isn’t willing to open. The 2 wires from the pilot (thermopile) should both be connected to PP terminals.

With the digital controllers and timers on the fronts? I mean it’s possible to remove ALL that crap and make em mechanical thermostat millivolt systems, it’s just funny to do that to such a digital unit. Once the touch pad or control board dies instead of spending the 1,100 to replace it do a conversion. New pilot assembly, therm, high limit and gas valve. Booyah no more expensive repairs.

Thank for the help. Do not know why kitchen managers want this digital stuff mechanical is so much more reliable.

Things are seldom reduced to the problem is “X”. But if the burners fire until the unit hits 350 then satisfies and never retires it could be the wiring to the co trip circuit is incorrect and instead of dropppng out the burners it drops out the pilot (which means it won’t reheat). Or it could just be an out of whack thermostat or probe depending on which kind of unit you have. More details of exactly what it’s doing and I can possible help more.

Such a fun word.. Ferrule 😂

@@restaurantrepairs words don't matter my friend you've got the know how, keep up the good work and thanks for sharing your knowledge with us. Much love from 🇯🇲 jamaica