Great video. I would have gone with the 6" riser so the lid is a little closer to the ground.
@jameshoward1215 Жыл бұрын
That tank need pumping
@murphymanor247 Жыл бұрын
Just curious as to why you didn't assemble the riser prior to placing the mounting plate? You wouldn't have to be over the waste and you don't take the chance of dropping tools and screws down in the waste. Also did any of the tape on the inner circle hit the tank top to seal it?
@theedge0077 Жыл бұрын
In retrospect that would work, don't know why I did it the way I did. First time I guess. The tape is pretty thick and it hit the tank top almost all the way around.
@Golgi-Gyges Жыл бұрын
I think I would have used caulk, in addition.
@pastorcharles3 жыл бұрын
Do you know the dimensions of your square lid that was removed? I have an 18 x 18 square lid with about a 25.5" diagonal.
@theedge00773 жыл бұрын
I believe those are the same dimensions as mine.
@starhawkrichards48312 жыл бұрын
What kinda of screws did you use? Will they hold up over time?
@theedge00772 жыл бұрын
I used stainless screws, I made sure they were us made so I'm pretty sure they are good quality.