3mn set screw on the shaft!!! No wonder this dam thing wont come off. I appreciate the help sir!!!

Awesome! That damn SET SCREW! You are my Hero! Thank you so much! The 8mm machine screws also did the trick! Both procedures you showed made the operation easy. Very clear and easy for anyone. You have great communication skills thanks for making this video!

Excellent video. I'll be using your info when I take off my pump. The 8mm bolt technique reminds me of a time I had to use a wheel puller. I did not realize the pumps might have 2 threaded holes to accomplish this. Also quite wise of you to put pieces of metal to spread the load on the end of the bolt so as to prevent damage to aluminum motor housing. Thank you!

Well, after about an hour of fussing’ and cussing I found your video. 5 minutes later the old pump was removed. Thank you very much.

the bolts were a great idea. Mine came out a little and then snapped with the bolts. We ended up using a saw saw and it actually chopped up the thing relatively easy. Your tips helped though.

Very good video thanks!

You can take a heavy duty ratchet strap and tie it to the pump and ratchet the pressure washer then ratchet the pump and bingo it should snap off from the pressure of the strap being ratcheted

Hmm no set screw and no threaded holes on my Comet pump, still stuck on shaft. Took pump apart and heated the collar around the shaft but still no go.

The pump on my engine is slightly different to what you are showing.

Great vid. Bet that set screw holding pump catches many out. Metal plate a must to save damage

Bro I can't find a set screw at all man help help ⚠️⚠️⚠️⚠️⚠️