Glad to have you back D-Ray. Y'all were missed.

What an unexpected surprise. Glad you’re back!

Great Video! I'm have the same problem with my Midsize 570. Going to check fuel pressure.

Nice to see ya back posting videos again D-Ray, been a spell. Like the bleeder function that I haven't seen someone do on a gauge set up to do fuel pressure, that's an awesome feature, I will be all over borrowing that genius feature. Great time and money saver. Hope your keeping busy and all is well.

Thanks D Ray for helping the average person ☝️👍

Great to see a video buddy..

Great information, this was a lot of help.

Good job, D-Ray!

The master is back!!

You must be a good man, I base this on your dog.. Thanks for the video.

Awesome content. Good stuff

Do you have a list of the parts (Ebay or other) to DIY the adapter?

Great to see another video from you! Loving step 1 Remove dog. It's crazy how the dealers wanna sell you entire an assembly, when its usually the same companies that make the pumps. I'm guessing its a wahlbro.

Solid video right there

Great video

I am going to try this. My husband is NOT a gear head, but I am. Wish me luck!

D-Ray. What is the part number for the replacement pump that you used. Or a link would work awesome.

Hey D-Ray, thanks so much for posting this video - it is awesome! I replaced the fuel pump in my Ranger 570 SxS and then checked my pressure, and it's reading 50+ psi... but I'm still having the same symptoms - it starts and will run for a couple of minutes, but then sputters and dies and then backfires. Any ideas what I should test next? Thanks in advance!

Why don’t i see people testing pressure on the fuel rail where the valve is? Handy video.

Where would I find a pressure gauge set up do you have a part number

not for nothing but i read a comment on another polaris sportsman 570 video which has a almost identical fuel pump set up and it seems as if the fuel pump gets loose in the housing and the o ring on the pump output looses its seal and you loose pressure and there is nothing wrong with the pump at all. i stuck a piece of plastic on the back side of my pump and the housing to take up the space and keep the pump tight in the housing and fixed it like new. this is a piss pore design by polaris shame shame. thats what i get for buying Chinese instead of Japanese lol i bet a lot of people are buying fuel pumps that dont need them and this condition will always show up ass a bad pump polaris should issue a recall . hope this is helpfull

Hey D-Ray. I have a 800 Ranger Crew and looking the the rebuild kit. You Said you found it on e-bay for $30. Can you send the path to find this? You put out a lot of good info. Keep it up!

What self diagnose online are you talking about? Where and what do I need?

Dealer must hate you....I've seen a vid or 2 of yours in the past, but I didn't really have a problem, I was just interested....now, I'm gonna watch a few more, trying to track down my compression troubles on '03 Sportsman 500. Thanks for what ya do, and the music is alright, too

The entire pump assembly is removable. Rebuildable and replacable for fractions over new complete assembly.

Iv gotta 2011 Polaris Razer Ranger 900 xp.It won't turn over I put a one way bearing in it but I didn't use a torch wrench to get it just write,so if you could help me out do I use footpound,or inch pounds to the write speackes?

Video 9/30/2018. Troubleshooting fuel pump Your video is quite old but I like the harness with quick connects to the pump and to the fuel line…. My sxs is a 2013 Polaris xp 900. Any chance of getting the quick connect part numbers you used? Not sure if the 570 in your video has the same size fuel hose and pump outlet as my 2013. Thank you

On a 06 Polaris sportsman I have to cycle the key on and off three times to get it to 39 which is the right pressure but it starts going down slowly and when on it running it keeps the pressure

Do you know where I can buy that adapter harness at

2011 polaris ranger 800 fuel psi at 40-41. Having issues with cold starting and low rpm dieing. Runs great at idle once it finally starts and runs great at mid to high RPMs. New Tmap sensor and harness, new TPS sensor and harness and 4miles on the rebuilt 800. 🤦‍♂️

Like your dog. 😎

D-Ray thx for part 1 & 2 for test ranger fuel pump. I bought a test kit and fuel pump was putting out 58psi. So where do I go now. 2013 Ranger Crew 800 EFI. Runs good at first but then bogs down, back fires stops. But it starts up and repeats the bog and runs ruff and backfiers. Again first of day runs good but then goes bad.

Where did you get that test reg?? I have a fuel,pressure test kit but I can't find the fittings to make the test rig

where can a guy get that fuel pressure adapter? to hook the gauge up?

I have a 2016 that was running hot, I replaced the top end (the piston had a hole burnt in it) along with a new injector. Its seems to be starting, idling and running fine now, but I removed the spark plug the other day and it still seems to be running hot. Could insufficient fuel pressure be the culprit?

Love the Video"s and really like you helper ! Anyways got a 2013 4 - Seater 800 RZR - with very low hours -------- all me and Grandma ever do is give the grandkids rides ------ it's been to the river 1 time. Well anyway can't hear the fuel pump cycle anymore ---- I've got 5.2 volts going to it ( is that cool ? -- shouldn't it we 12 Volts ? ) on the first wire on the plug. Engine cranks , but no fuel and of course no start. Can't believe fuel pump is out with so little hours on it .... Your thoughts ?

i have a crancking problem/when engine gets warm

Seems like I always have a problem with Step one of this video! But she is my riding partner and we seem to work it out.

Love the video. Where did you get your fuel pressure tester with the Polaris quick connect ends so you can easily just book it in line??

I can’t find anyone who carries this pressure gauge. Can you give me more information on it?

where did you get that fuel pressure tester?

E-Bay has em for $49.00 complete pump, ring, plastic screw lid.

You all are fooled