As a dad learning how to maintain a PW50, I Thoroughly enjoyed this video and now feel confident in cleaning its carb and air filter. I raise a glass to you, Cheers.

This is a great video - very thorough, not to fast or slow and no annoying music.

I was gonna subscribe and then I saw the man bun 😂

thanks for this mate, very helpful!

Thanks bro save me some money

i was looking up carb rebuild kits , and found entire carb for cheaper. lol. These bikes are soo cheap i decided to just freshen up the whole bike. I got a new carb , filter , entire top end with piston seals bearings cylinder and head , for less than $150 shipped.

Helpful, thanks!

Great video…. Did everything word for word (I think)…. Turn on fuel, leaks like crazy coming out of overflow line. Starts with choke only, otherwise shuts down when choke off. Switch to “run” and bike revs high.

Thank you! Great video - So do you recommend using a rebuild kit like ALL BALLS or is it enough to just clean it?

Good video. I've also replaced the oil pump with a plug. What did you use to seal the port hole on the carb?

I was working on my pw80 and we were striping it down and we got to the air filter. And there was no spong

I wanna ride the z rem!!

How can I replace the entire carburettor? You didn’t take it apart completely. Awesome video none the less mate!

Great video and info!!! I do have a question you mention you pre-mix your gas and oil at what ratio do you pre-mix it at? I recently installed a Wiseco piston I installed a rev plate under the cylinder had the cylinder worked 20over I believe installed boyesen reeds and new crank seals. My last question is did you do any JETING to the carb? If so what works best for you? As far as jet size?? Again great video and Thank you sir!!👍💯

Just wondering if you have any suggestions on front fork replacement.

How did you eliminate the oil pump? Did you block it off from the tank or did you actually remove the whole pump?

Nice video, also like the arctic monkeys as the background music. I'm ready to go fix my pw50. I just subscribed

Any tips how to spot a py50 to a pw mate

Just got a 05 pw50..been sitting for few years, installed new plug,new air filter, gas tank, lines and carb..all it wants to do is a low idle and cut off when throttle is engaged..any ideas?

What year is your pw50?

Bro were in aircleanare

Time for a better camera

I got a 97 pw50 2 stroke and I can get it to idle but not have an throttle response. Pretty much all of the parts are new and I've checked everything I can. Any ideas? Here is a link of what it is doing. kzfaq.info/get/bejne/n7uoYJqa1ZuRYZ8.html It has a 60cc big bore kit, new wiring harness, exhaust, carb, spark plug, stator, kill switch, coil, air filter element, fuel filter. It has good compression, it's getting gas, no exhaust restriction (it's off in the video), I've tested the switch and I get good readings when I should and OL on my meter when I should. I'm totally stumped although there can't be anything left to try that I can think of.