Great video! I am just getting back into rc after having my Traxxus Pro Trax and Team Losi buggy rc boxed for 20 years in storage after my son's grew up. Alot has changed and I am slowly learning thanks to peoole like you posting these videos. Great job!

Hello from France my friends. Thank you for your very good work :-)

Yep, ive had to deal with this many times on my arrma vehicles. The infraction i had, i set it up as u know for 100 mph speed runs, it was one run and done, but sometimes i kept doing multiple runs. Big mistake, and i learned that to the point that my esc overheated and the motor cut out, i was running 34 spur 27 pinion on a 1650kv motor. Stock gearing was 46 spur 18 pinion. Also when trying to line up my mod 1 34 spur with a 26-28 tooth pinion, i noticed it wasnt meshing, because of the gear pitch, i was using a 0,8mm pinion when it should been a mod 1 pinion. Great video ryan.

You are awesome man! I wish I would have found your videos like 2 years ago when I just got into RC's would have saved me alot of headaches lol

Thank you. Once again another very informative video.

Very informative video great info sir keep it up

My setup has a sensor and will stop power going past the ESC if there is too much heat into the system. This is cool but my motor kept overheating after maybe half an hour of hard drifting. I have bought a motor fan, but didn't test it yet. Hopefully it's good enough to keep it from overheating

Awesome stuff, love your content. Top gear top tip, let your thread locking compound cure for 24 hours.

Traxxas does this from factory. .08 mod spur and 32p pinion

For torque, what is the best gear 48p or 32p...?

Not gonna lie didn't know 32pitch and 0.8 was slightly off

Commented before on this video if your in a "pinch" 0.8 mod and 32P will and do run fine. If you find a gear mesh that's imperial and metric within a few 00.0 of each other, then YES! You can put two pinion pitches together. Don't know why you delete comments dude.