First mistake: Your output straw needs to be wider, the input and output cannot be the same thickness or you've got the same pressure on both ends when the water starts flowing out, and that will do absolutely nothing. Also, the output has to be as close to the bottom as possible, and the container cannot be flexible or it negates any vacuum created by the water flowing out. You also absolutely must have more water flow out at the start to create the vacuum than the amount of water that will be coming in. You have 3 forces working together, atmospheric pressure, vacuum, and gravity. Gravity acts as a constant input of energy in this device.

自作聰明改動了正確的設計。所有成功的大型裝置→1來水使用細喉小管，去水使用粗喉大管（水管粗幼的比例是I比4或I比3 ） 2小小瓶子的水平面蹟不夠大→平面太小了，未能產生足夠的空氣壓力 3水柱的深度太短小了 也是重力水壓不足的原因。4重覆檢查水密封，不可漏氣。5最主要的原因 → 不学無術 偷工減料 自以為是 自作聰明 改動設計。

What if you take the orange straw the outflow and extend it into the reservoir breaking the water tension would it create a circulation if it does create a circulation one could put a turbine at the elbow to create electricity possible

Thank you for help and informing us because I also getting try to this experiment so you post this video I thankful to you for do this experiment for us public

But bottle se pani nikal ne ka bad air pressure kam ho jata hai, is liye pani ko khich sakta hai lekin air to pani ka niche to nahi a sakta , so I think isiliye pani ko upar ki pipe se khichta hai, lekin kahi lickage nahi hona chahiye, aur bottle se nahi hogi , bottle sikur jayenge, I think hard material se ho sakta hai

You must just have a much bigger water Volume at the output Pipe...only then it might work...so connect a second bottle at the water outlet and fill it additionally with water....

you should give it a pressure, the water will flow for you

Super bro. I would have saw this before trying.. One bottle would have saved

Exacto no funciona lo he probado de muchas maneras y la única que si funciona es dejar el tubo de abajo mas grande, pwro al final por salir mas agua que la que absorbe, se queda vacía dentrp de poco tiempo.

the weight of the water in the outflow pipe must be greater than in the inflow pipe. It is necessary to increase the diameter of the outflow pipe and lengthen it and at the end reduce it to the diameter of the inflow pipe, because the water will flow at the same rate as in the inflow pipe

You broke my heart. But thanks....

Your a blessing! I finally made one after watching all kind of video's, your's was the one that show me.. Thank You

its working at my end, u need to close both pipes open end and remove inlet pipe's opening last.its not again physics water can move from down to up also, just link/connection of water should be created at perfect timings

You have bottle too full & intake submerged. Atmospheric pressure blocking flow. To force water up straw, youd need suction caused by the gravity pulling water. But the suction is blocked by the water being over the top of the yellow straw in the bottle. When you uncapped it pressure/atmospheric pressure released & gravity brought all water to level.

Not fake brother i have tried at home with 500 ml water bottle its really

Good job

Sir jaha se pani collect horaha usse niche delivery pipe ko lagana hoga.syphon tank jada bàda hoto acha hoga

Why not tighten the lid again once it starts going?

Energy can be neither be created nor destroyed. We know that. Thats why we make two hole. One output and 1 input. Trying to re used the energy cost in the output to input it but there is a height difference so the out put should be larger that it will become equivalent than it will work

Holaaa,Lo hice así mismo y no echa agua,no me funciona ,que puedo hacer?

very very thanks Main karne hi bala tha lekin appp ki video dekh kar me Bach gaya❤️❤️❤️😲😲😲😲

The output pipe must be much longer and bigger than the input only then it will work. And the storage must be big

Haa but hawa ke presser se wapas niche ka paani lena chahiye tha yll ?

to make that thing work is all about the right computation of water volume inside the bottle, the right size of bottle, and with a help vacuum plus the right height of the bottle above the ground just to work the law of gravity... to make it simple.. water volume/bottle size, intake pipe/length/size, output pipe/length/size. The last and the most important is you must completely sure that it is air tight, meaning the only way that can past through the bottle with water and past through out is the intake and output pipe.. correct me if Im wrong or if there is missing with my explanation P.S. I made that thing work with the help of science and math and im using it now in my fish tank..

Very very nice video. your video helps a lot me and my friends. thank you so much keep it up.👌🏻🤗

well fone brother

Outflow water level should be below the reservoir water level, then water will flow irrespective of the diameter of inlet or out let pipe, 👍 this is law of water level. ಇಂಚ ಉಂಡು 👌

Soon after you filled the water and released your finger, air bubbles entered the bottle from the outlet side. Hence your arrangement was not airtight and hence the result is not conclusive. Please repeat the experiment with complete air tight arrangement and observe the result. Your set up was neat and clean; good.

Fake nhi.. yellow straw k level k niche pani bharo.. It works..

If u remove the yellow straw it will work

Tendras entrada de aire en las soldaduras. Corrobora esas penetraciones y funciona..

Thank you for letting us know 🙂🙂☺️

good work dear ,thanks a lot

मैंने ट्राई किया था पूरी बोतल दब जाती है लेकिन पानी नहीं खींच पाता .

good

Thanks bro pehele menebhi try keya lekin kam nahi hua

Thank you for your video

Thik kaha bhai apne mai bhi ye KZfaq par dekhkar bana raha tha par nahi chala 😭

Ha moj ha tenks

U need to keep the water level below the upper straw pipe inside the bottle.

It will work for some long. Until the work done to pump the water reaches equal to the work done to fill the tank

not really... u could try and close the vessel inside which the water is draining in such a way that it is vaccumed

Gajb

and one more tip... use silicon glass sealant that we use for our aquarium because it is water resistant than the glue gun

it really works..

Jab bottle me Pani bharo to adha bharo Aur phir dekho chalta he ya nehni Me ek video dekh kar ghar pe try Kia tha Aur achhe chala

You need to have biger ouput sothat the pipe has a greater vaccum force to pull enough water from the source

thank you for your information because I almost did this for a group project😭😭

Jinke fountain chal rhe hai,10 minutes ka video bana kr upload kare,Rs 1000 ka inam diya jayega.fake sabit hone pr FIR karai jayegi

what you did is wrong... the inlet straw must not be submerged to the water...

Bro Thanks for truth MA to pagal go Gia Tha try Kar Kar ka

Thank bro

Apka sistem tik nahi huy bhi?

Right✅

You tell right because this is really fake

The top tube must be on air, not submerged. Try again!

Thanks you so much

but it did work on my tank,you just need a bigger volume of water from the thank so that the pipe submerged sucks the water

आपणे ये झूट दिखाया येत अच्छी बात है। कुछ लोग चंद पैशेके लिये ऐसी झुटी बात दिखाते है।

U right bro its dose no suctioning i did try also ❤u

True

App ne thek kaha Bhai Jan me ne b banaya tha no chala

It is real but we make it air tite

Must hai or very very nice 👏👏👌👌👍👍

No Brother i have create recently and its working Fine

Thanks you bro

সারাটা দিন এটার পেছনে লেগে বসে ছিলাম কিছুতেই হচ্ছে না ঠিক তাই আপনার রিয়েল ভিডিও দেখিয়েছেন

Strange worked for me

Thanks bhai

Air has to do less work done then water thats why not flowing

भाई, मेने ये एक्सपेरिमेंट कर के देखा हे, और ये चल भी रहा हे, ऊपर वाली पाइप के नीचे तक ही पानी रहना chaiye, पानी और हवा के दबाव से fauntan सही काम कर रहा हे।

Water level must have below the top side strip

Aap ne sehikha 😘

Great Bottle have a Suction. The deeper is the water need more suction. The outlet is higher it need less vacuum. So the water will flow to the deeper level.. You people so fulled with the weight of the water. It's not count... The vacuum measured by cm².. Fake

Thank you

May bhi practical kiya hai success nahi hui

Ye bird k water ka accha system h ..free pump to nahi h.

This experiment work with big bottle

Tools?

the tank shall be bigger so their is more gravitational force acting upon the water molecules.. also when straw will be deep inside.. the water pressure phenomena will act alongside the higher gravitational force due to more molecules

Yes

Oh

thanks

you need to cut the orange straw.

hear is problem ,,plastic botol..when the air force for water down to up this time this botol will be loss his thikness,...

Tq already try this these is a fake tq

Молодец

अगर नीसे बर्तन से बॉटल के अंदर एक और पाइप दल दिया जय तो हो जाएगा

Try again it will work

बोतल के हिसाब से छोटा पाइप इस्तेमाल करो

Your right it doesn't work any way you try it

Trop d'eau dans la bouteil et le bouchon a la place il faut un plastique souple pour faire pompe😉

Thanks

No le anduvo xq lo hizo mal una pena xq si funciona

Brilliant

doesn't work that really is air pressure block the folw through pipe

بالکل صحیح کہا یہ کام نہیں کرتا ہے

this video is real in work

Yes. U r right.

Niche ki stro uper ki stro se badi rakho