Removing the TIMING BELT on the VIVARO! THIS COULD HAVE DESTORYED THE ENGINE!
Рет қаралды 19,443
Жыл бұрынThis timing belt isn't looking too hot. It might go bang. So we decided to change it.
Why should you change your timing belt at the correct intervals? Because if you don't, engine go boom. Pretty much. So we get the belt changed on the Vivaro and DAMN, it's lucky we did it when we did.
We have uploaded the videos from the old Harrison Watts Restoration channel. To rewatch, all videos are in the Harrison Watts playlist
#autorepair #vivaro #vanrepair
@mrmadness69 8 ай бұрын
The bolt doesn’t have to keep in. You can take it out once tight in. When van vibration bolt come off anyway.
@RD-650 5 ай бұрын
Good job 👍
@Elysianplains Жыл бұрын
Well done 👍🏻
@yumyumbaboon 9 ай бұрын
I’ve tried using those apps for tensioning cambelts on my Ducati and got very irregular readings so I use the old school method using an Allen key as a feeler gauge. I’ve probably done a dozen belt changes over 20 years and never had any issues so guess it works! NB, I usually err on the side of slightly slack, especially on an air cooled motor, as it’s extremely rare for a belt to jump a tooth - it would need to be hanging for that to happen! 🤩
@SoloBench Ай бұрын
Doesn't need the screw in. The other bolt is to secure it
@leemusselwhite9677 25 күн бұрын
Omg the cam belt should be changed every 5 years or 50,000 miles on the 1.9
@fred1987randall 7 ай бұрын
How did you remove the torq bolt from the crank? Its a bloody knightmare!
@sailingdarren 4 ай бұрын
hi there can you take the water pump off without taking the timing chain off
@henrikf2822 11 ай бұрын
Hi there, I didn't quite get it at the end. Was the fuel pump timed or not?
@DanTheMan-chanic 11 ай бұрын
No fuel pump isn't timed. The timing comes from the injectors. The pump just keeps constant high pressure through the (common rail) fuel line
@henrikf2822 11 ай бұрын
@@DanTheMan-chanic Thanks!
@bikerlad3138 10 ай бұрын
@@DanTheMan-chanicare these hard to do I’ve done few berlingos they’re easy but got to replace high pressure pump on one of these
@henrikf2822 10 ай бұрын
I only payed attention to Crank-Cam timing, and engine is running fine.
@RD-650 5 ай бұрын
Good job 👍
BalcevMMA_BOXING
Рет қаралды 21 МЛН
АвтоСтронг-М
Рет қаралды 140 М.
Гаражик.
Рет қаралды 26 М.
Garagen - Schrauber
Рет қаралды 159 М.
Matt Motorsport
Рет қаралды 191 М.
КИНОТАЧ
Рет қаралды 906 М.
ОДНАЖДЫ В СОЧИ
Рет қаралды 4,2 МЛН