Repairing a HIGH MILEAGE Truck in the RUST BELT Part 2

Repairing a HIGH MILEAGE Truck in the RUST BELT Part 2 - Frame Treatment

Рет қаралды 17,144

5 ай бұрын

In part 2 we will be treating the frame, and doing miscellaneous repairs while the bed is off.

Пікірлер: 24

@cgonedfishing 3 ай бұрын

Love it! Congrats!

@lisadan66 5 ай бұрын

Keep em coming!

@bradweber3238 5 ай бұрын

Just got done doing the same thing here. Except we went one step further and used surface shield for our last pass.

@madphilx6397 2 ай бұрын

Bet your wife was happy to get her garage spot back!

@thomastieffenbacherdocsava1549 4 ай бұрын

Learned something!

@janettavculek9308 2 ай бұрын

Me too.

@Kurnacopia 3 ай бұрын

$2.75 a gallon? its $4.09 where I live in AZ.

@AxGarage 3 ай бұрын

That's what prices were at the time. They have gone up since. Believe me, I wouldn't undervalue the cost of a full tank of gas 🤣

@JoeyG1973 2 ай бұрын

Yeap music comments just got you a subscribe.

@AxGarage 2 ай бұрын

Thanks!

@aljonnfernandez8231 2 ай бұрын

whats the name of the rust converter?

@AxGarage 2 ай бұрын

Corroseal

@WiSeNhEiMeR-1369 3 ай бұрын

Thanks COOP ...

@philliphall4506 5 ай бұрын

New subscriber!

@shawnsmith4058 4 ай бұрын

How's about inside frame tubs ?

@AxGarage 3 ай бұрын

Inside the frame tubes? I just stuck the brush as far in as it would go.

@shawnsmith4058 3 ай бұрын

After painting I have sprayed old gear lube in frame rails little messy but helps

@shawnsmith4058 4 ай бұрын

It would have been cool to protect new fuel pump

@doneadiizua76 3 ай бұрын

Please please dont play any crazy annoying music, just cool jazz ok

@Sup_Evox 2 ай бұрын

That’s not even that bad my bosses truck looks toasted

@TinCupChef 4 ай бұрын

Can't you just paint the frame with Eastwood Encapsulator Plus without doing the rust converter??

@AxGarage 4 ай бұрын

I used Eastwood's rust guide when doing research. They state " For the best protection, we suggest applying rust encapsulator over the converter and then applying the top coat."

@JohnClarke808 3 ай бұрын

@@AxGaragethe adhesion with the Eastwood sucks. Rust Kutter is by far the best. POR sucks it peels off in sheets even if you chip it, brake fluid will eat it. I've been using Rust-Oleum oils base with an activator, it holds up greats and doesn't chip and remains flexible