I appreciate the video, my old man has been in the hospital and i couldn't have fixed my truck without this video.

Ya know,,, all I can think when I see thumbs down on great explicit videos like this is,, that there are people who are so miserable in their own lives that they just have nothing better to do then just go video to video thumbing them down without even watching them! This was the best how it's done video start to finish I seen so far! Thank you so much! I seen how the plug lines went on correctly ( since mine were played with and coulda went either way) before you taken it apart all the way to where exactly the vent gets attached behind the coil spriing! Great video! Helped me immensely! Thank you for posting this!

Probably the best video I had ever seen with great detail. Thanks

Beautiful work, most helpful. I didn’t know how the system works until I checked out this excellent video, thanks, Dave!

Thanks for the effort of producing this concise video. I'm about to make the same repair on my Dodge Ram and it's nice to see all the components up-close and clearly shown before I climb under my just recently Fluid Film coated truck. Much appreciated!

Excellent video. Straight to the point. Excellent job.

Great video, I like the way you explain things. Not to fast and very clear. Thanks

excellent and clear .the best one I have seen on this process

Fantastic video, it was super easy to understand and right to the point. This was extremely helpful and exactly what i needed to see to get me running again. Thanks a million!!!!

Thank you for your video, I'll check vacuum once the snow melts

Very good video! Very thorough! Thank you for making this video!

Very detailed video. Excellent job

Thank you so much for your video! It was very informative , very thorough, help me out tremendously mine was quite a bit more rusted then Yours some WD-40 and some time and patience I got it apart got to put back together and now my 4 wheel drive is working again! Thank you very much!

Thanks Jay. Great video. Tony

Just awesome no bs just teaching. Keep it up

Awesome video man!! Very detailed!!

Outstanding how to video. I am impressed with your thoroughness and sequence of action. Well done and thank you.

Excellent video!!! Very helpful.... Thank you...

Thank you! This video was very helpful!

Thank you Jay... very helpful and clear instructions

Thanks!!! I’ll be doing this next week

Excellent detail.Thanks

Excellent Video!

Great video, help me 100% point to point really good video, thanks

Appreciate the info, thank you

Excellent video!

Very detailed video excellent job thank you very much for posting God bless

I know this vid is 3yrs old but a question for anyone willin to answer, the red and black vacuum lines on the actuator, do those both have vacuum pressure while the truck is runnin?

Thank you very much - very helpful.

Thanks. Excellent video 👍👍👍👍👍

Well done full of info thanks you would make a super instructor

Thanks Jay, nice to not have to reinvent the wheel!!!

great video

Thank you for your video and your teaching, it helps me a lot to fix my truck, thank you very much for sharing your knowledge and experience, a new subscriber to your channel👏👌

Nicely done

Great video ,, thanks

doing this tomorrow thanks good stuff the only thing i would add is if you have a compressor blow through the lines to make sure no leaks or stopped up like mine was.

Excellent!

That I haven't seen in many post and forums this is a very good informative video very detailed so great job on that but also zit pops on control the light is coming on but it's not actually going into four-wheel this is going to be my next thing is doing a pressure test to see that if it is holding a vacuum if it isn't then we know that that's a bad diaphragm and I'm going to replace it thank you

Thank you for a great video. Very helpful and informative. 12:10 12:10 12:10 12:10 12:10

Hi, old video but this helped a lot! How much oil should I put a into the axle at the end?

Like everyone else says awesome video

i need the little black and red hoses - do most parts stores have them ?

great video.. very well done. I was told that if the front driveshaft/axle wasn't engaged that the truck would roll if it was in park. if one front axle is split by this collar how could that be true? it also seems that the opposite side axle would be working the differential to death in two wheel drive. What am I missing here? Is the transfer case constantly in 4wd to keep this from happening?

This is instructional video is very well done. What is the source for parts, particularly the yoke shoes?

My light stays on in 2wheel drive, in 4x4 it turns off. Does this mean my 4x4 is stuck and engaged? One time the light went off on 2H and also stayed off on 4H. I tried changing the sensor.

Seen a hose hanging from bottom of my truck; turns out it was just the actuator vent hose...thanks

Great video. My lever on my 99 Dodge Ram1500 is difficult to move from 2H to 4H, N and 4L but after toggling the lever a bit, it does move to 4H and I see the light on the instrument panel. I got this truck a month ago and truck works great overall but I want to figure out how to make it easier to move the lever. I am not sure if related to the vacuum actuator or shifter assembly needs some WD40 so shifter moves easier like yours in the video? Any ideas? Thanks.

Aight guys .. need some help ... Where does the last line goes attached to after the clip ... Cuz mine is broken and the hose is hanging out till the connector

If the 4x4 light comes on, does this mean the actuator is working correctly?

Thank you for this video,my truck is stuck in 4 wheel drive,can the actuator cause this problem ? The truck went into 4 wheel drive but it won't shift back out .

Currently doing this on my first gen. I can not for the life of me get the new diaphragm installed without destroying the part or myself. The original diaphragm had to be hammered out. Anyone have any tips?

Anyone here after watching that 1A auto video?

I’ve got a 96 ram 1500 4x4 but I’m always scared of putting it into 4 because of grinding noises. Am I not supposed to be in neutral or is something wrong?

Does it matter if I take that piece out with 4wd engaged?

please tell me where you got that punisher emblem on the grill

Unrelated to the video itself, how or where did you get that punisher logo on the grill?

Just a fyi for everybody-- test your new actuator before you install it. I got two bad Dormans in a row.

What about replacing the fluid inside the front differential?

Where did you get the parts ? Nobody seems to have them anymore. Dodge discontinued them in 23 july

Awesome Video! Curious to where you found the punisher emblem?

What if the light come on when in two wheel drive but goes off in four wheel drive

What were the symptoms of having to replace this actuator?

Where did you get the hood emblem???

Mickey mouse. 4x,4. I can't believe. Dodge does really suck. Hubs nice. Vacuum. In 40 below?