I do not know how to thank you. A 1 month old new RLC-830A stopped working. Your video allowed me to restore it to 100%.

Frustrating that they left out two wires to save fractions of a penny. Thanks for solving the modified wire layout!

I encountered the same problem, I have 3 cameras with the same problem, you saved me man 👍 Cameras are working now thanks to you...from Saudi Arabia thank you

Well that works ... fired up a dead camera Reolink 811a. Already had the kit so that's a complete freeby. Thanks for your time and efforts making the video !

Dan, thank you so much for sharing this video. I had ran into the same problem with water damage to the end of my outdoor security camera. I thought it was toasted and about to purchase a replacement. Your video saves me $$$. Thanks again, and please keep up the good work.

This post saved me. Thank you for sharing this, I have a RLC-823A that had water in the Ethernet port and broken pins. Managed to salvage it by following your instructions. 🙏

Totally helped me fix my rlc 833a. Used the water shield but it was swamped and burnt. Wiring setup was exactly what I needed. THANKS!!

This video is great, thank you!!!!! saved me from having to buy 3 replacement cameras, as the ones I had suffered oxidation on the copper pins inside the RJ45 jack. Now I own a new pass-thru crimper tool too! Much better than the old stub-end ones.

Fantastic, I had two POIs water got into even with protectors installed correctly. Making my own this time. Thanks repaired both and they worked first time. 🙃

Thank you! Im gonna try this one later

Thanks for helping me figure out the pin configuration.

Thanks so much for the easy to follow wiring diagram. This fixed my problem in a cinch. Thank you! 🙂

This video just saved me a lot of money that's what it did!!!!!!!!!

I got some splice boards desoldered the punch down blocks. Sliced the camera port, soldered to PCB for splice. Soldered cat 6 on other side, potted the monstrosity with silicone. Been back in business for a year.

Thank you SO MUCH for creating and sharing this video!!! Exactly what I needed! 👍👍

thanks for sharing the pinout! it works ❤

Thanks for the video. I had watched a few others, but the colors of the camera cable were different: in yours the combination is exactly as in mine. However, in my case the problem persists. The camera gets power but doesn't give me image. I might try repeating the process but a few inches closer to the camera, past the spot where the cable splits into RJ45 and power jack.

What size should the coupler be? Is the size standard or do you need something smaller to fit into the waterproof box?

Works fine , thanks

Hey 👋