Рет қаралды 2,656
Thanks to our clips-on bars, it is possible to be even more aerodynamic on our Noah Fast, Kanzo Fast or any bike using our integrated cockpits. These clip-ons are compatible with Ridley N1 and G1 cockpits as well as Forza Cirrus Pro cockpits.We have prepared the following step-by-step guide for the installation of these clip-on bars.
Required materials/tools:
- Allen key 4mm
Step-by-step guide:
1: Open clip-on clamps
2: Determine spacer height and Choose the bolt that fits the amount of spacers + 10mm. ATTENTION: bolts to be different length when angled spacer is used
3: Mount the spacers and bolts on top part of the clip-on clamps
4: Choose the right threaded insert for your case: using angled spacer vs not using angled spacer. ATTENTION: Make sure the insert is pointed in the right direction depending on the angled spacer direction, if used (U pointing up, d pointing down)
5: Mount the extensions on the clamp/spacer pre assembly
6: Install the other threaded insert on to mount arm cups
7: Install arm cups using M6x15mm bolts
8: Determine position of the clip-on bars and protect the handle bars with electrical tape
9: Install the clip-on bars
10: Stick arm pads on the arm cups
11: Push bar end plugs in extensions. ATTENTION: Make sure to install handlebar tape and/or Bar end plugs (not included) on frontside of the extensions as well if you are planning to race, this will probably be mandatory