The LEDs from the stock bumper definitely fit. You do have to pull the bracket off the stock bumper and mount it the the Rugged Ridge bumper but they fit perfectly.

Will do. 😂

It’s the Warn winch plate.

Under?. Splash guard or skid plate?

@@a.jr_moon Oh! That’s just the stock Rubicon skid plate. It’s to protect the electronic sway bar disconnect actuator.

Thank you!

Haha thanks!

Hey thanks for watching! We didn’t have to make any modifications to the Jeep at all. Hope this video helps you in anyway.

Thank you! I have a lot more videos coming. With the Rubicon package it comes with a steel skid plate to protect the sway bar disconnect motor. This bumper allows you to reuse that skid plate this is one of the reasons I chose this bumper.

Sorry to hear that I think you can print them off now and that why they stoped providing them.

Hey thanks! I don’t think there would be enough room to install the fairlead after the bumper is installed unless you fought it for a long time. Yes it’s a hex driver. I don’t remember the exact size but I can look after work today. I should do a follow up video on this bumper. The only downside to this bumper is when you reel the winch in, the bumper can bend slightly and pull into the winch and gouge it. Not super bad or anything just something to be aware of while your reeling in the winch after a recovery.

@@BTHAlaska I am planning to install the bumper next week with winch but the license plate will come 2 weeks later. >< Will wait for follow up video. Thank !!!

@@threefishes9893 No problem!

Just a tiny bit but it’s just from rock chips on the highway. The only thing I’ve run into is I now have 38” tires and when the tires are stuffed up and trying to turn the tire will make contact near the fog light housing. It’s not huge and I don’t have to worry too much but I’ll end up trimming it this summer.

Hey thanks for watching! The hooks do stick out about 2.5-3 inches passed the stock bumper.

@@BTHAlaska Darn! Thank you!

@@apexbmx5852 No problem! Stay tuned I know I have posted a video in almost a year owning 2 businesses put a damper on posting but I’ll have more videos out in the next couple weeks. Enjoy the trails!

I did not. It was tight and kind of a pain to put in but it all fit just fine.

@@BTHAlaska thanks. My first attempt was about 1/4" too wide. My second with the other one they sent me is the same way but only maybe 1/8" too wide.

Where are you in AK? I'm on JBER.

@@chrismcmorris306 I’m out in Wasilla but work on JBER. I can drive it in one of these days if you’d like to check it out.

Yea definitely! We will have to meet up one day. I currently have the bumper installed without the winch plate.