RM KL 503 mods and fan install

No video

RM KL 503 mods and fan install

Рет қаралды 5,591

Rui The coyote

Күн бұрын

just a way of wiring the fans so they don't keep running all the time
fan :www.ebay.co.uk...

Пікірлер: 20

@EdzashedFudwinkle 2 жыл бұрын

I have just purchased a 503, I believe I damaged my 505v when I blew up a 30a psu, possibly over-driven it. The 503 I only plan 4w Fm 8w Ssb from a CRT SS9900, and hopefully I can get the 505v repaired. Appreciate the video 👍🇬🇧

@philipriding Жыл бұрын

Nice job Rui

@paulshockieuk2651 9 ай бұрын

Hi ..could you tell me the make or a make of relay for this amp as mine is stuck in transmit..I need to fix it..kind regards paul ..uk

@ruiamorim1975200able 9 ай бұрын

Replace the relay

@BoB4jjjjs 3 жыл бұрын

You could have put in a thermal switch to run the fans automatically.

@ruiamorim1975200able 3 жыл бұрын

yes it is possible

@zukispur5493 2 жыл бұрын

Which is exactly what I've done

@corvette652 2 жыл бұрын

Great video. I was wondering if you could advise if this amp housing should also be grounded to vehicle chassis along with the power and negative going to battery terminals? Im getting interference when I key up my cb mic to talk in my RAM truck. When I key the mic and talk it causes my oil pressure gauge to drop. Goes back to normal when let go of mic or don’t use the amp. Any suggestions?

@ruiamorim1975200able 2 жыл бұрын

Good ground is always my favourite

@charlessalard4636 2 жыл бұрын

What if your power supply putting out 14 volts..Will it hurt fans??? I had fan it burnt out??I have italy 503 hd.

@ruiamorim1975200able 2 жыл бұрын

13.8v

@vsmichael1 10 ай бұрын

That’s a bad way to put that fuse in. There’s gonna be a problem, no question.

@ruiamorim1975200able 10 ай бұрын

the fuse was provisional as the fuse holders were removed

@vsmichael1 6 ай бұрын

@@ruiamorim1975200ableyou never stated that. Don’t leave it that way.

@jameswaddell3319 2 жыл бұрын

I HAVE A RM ITALY 503 THAT NEEDS TOO BE REPAIRED ALL MOSFET ARE BURNED OUT CAN SOMEONE HELP ME ARE KNOW SOMEONE TO HELP CAN PAY FOR SHIPPING COST TO REPAIR RM 503 LINAER

@ruiamorim1975200able 2 жыл бұрын

The shop where you acquire the linear should be able to repair you can always try to repair it yourself they are a bit tricky to work on is they are double sided board but nothing very difficult if you have a bit of soldering skills if the finals are burnt there is a possibility burnt tracks and other burnt components sometimes repair on electronic equipments does not compensate is the price of labour end parts can be expensive in our days that amplifier is 5 Watts drive only on FM so if you I have burnt the finals the cause might be pushing too much power into it I don't really contact for a electronics engineer I can do my work by myself but if you cannot find somebody you can always contact me you will have to post the linear to me

@vsmichael1 10 ай бұрын

Amazon for transistors.