Safe Door Hinge Finials On The Bridgeport Powered By Masso And Clearpath.

Рет қаралды 662

6 жыл бұрын

Put my 9x20 lathe on the bridgeport to make a cheap way to test if i want to build a turning device for the table and the answer is oh yeah. That will be the one of the next big projects for the mill rapid turn/ 4 th axis. Hope ya like the video and don't forget to like and subscribe.

Пікірлер: 8

@0Saints0Photography0 6 жыл бұрын

Holy awesome! I though of putting a lathe on the table of a Bridgeport a while ago but that was just a thought lol. Excellent job! I'll look back in your videos but I would love to see how you set up your Bridgeportwith the Masso and clearpaths and the cost to do that. I'm very impressed with your Yankee engineering!

@mowbetter2010 6 жыл бұрын

Well the mill it self wasn't to bad to setup with the masso at all. Hind tech has really got the masso running very well. Adding the mill was a little more difficult we had to reprogram the post processor for the fanuc generic turning to get it to work but after that it has smooth sailing so far. About 3200 to convert it with masso, ball screws, and clearpath servos

@jimgriffin8212 5 жыл бұрын

Very nice

@froglegs6384 2 жыл бұрын

Beautiful work. Would you consider making a set for me and how much would it cost. Thanks 👍🏻

@mowbetter2010 2 жыл бұрын

Yes we can make them a set of 4 in brass,stainless or aluminum will run 200.00 dollars up to 1.25” at the base. Bigger base diameters available just need to measure them before we can price them. Thx

@froglegs6384 2 жыл бұрын

Thanks for the reply how can I get ahold of you

@froglegs6384 2 жыл бұрын

@@mowbetter2010 hello can you send me a contact number to order the brass FINIALS

@froglegs6384 2 жыл бұрын

@@mowbetter2010 i measured the base of the hinges where the finals sit and it's close to 1" 1/8"