Setting Center of Rotation for a 5 Axis CNC Mill 202003190858211

No video

Setting Center of Rotation for a 5 Axis CNC Mill 202003190858211

Рет қаралды 27,558

Grand Prairie CNC

Күн бұрын

Пікірлер: 23

@cheeriomartinez 3 жыл бұрын

You would have saved me from so many headaches if I saw this two years ago. Haha great video by the way.

@stevejohnson8435 6 ай бұрын

Thanks, that makes it a little clearer.

@JohnBlaze505 2 жыл бұрын

*Laughs in TCP & DWO

@Eggsr2bcrushed 2 жыл бұрын

Need to take half the gap you found in Y from A90 to A-90 to get the proper Z axis shift. Also, most machines do not have a full +-90 on the A/B tilt axis. There are still ways to find MRZP though, just need to be clever about it.

@jr540123 Жыл бұрын

Makes sense, also note you can indicate the A axis laying down and then add or subtract to get taper out of a part that is done mostly laying down while being machined, as the 90 degree is not always a true 90 degree movement on some systems or if its just to account for slop in the table. Cause I've seen how sloppy a tr160 can get and still run day in and out, clapped out is an understatement.

@Duceytwoducey Жыл бұрын

set up videos are great! thanks!

@ExplodingPinappleHD Жыл бұрын

Ya this video was awesome. Trying to figure out our haas tr100 at my school.

@Emanemoston Жыл бұрын

Thanks for the video.

@zaz4667 5 ай бұрын

AWESOME!

@maximiliencorces1784 4 ай бұрын

Thank you sir

@nageshkadare970 Жыл бұрын

Amezing

@cristinelpricop 4 жыл бұрын

very informative !! Thank you !

@marcsolorzan9487 Жыл бұрын

Way big reunion for the vf2

@marcsolorzan9487 Жыл бұрын

Trunion*

@engmoneermusa4470 3 жыл бұрын

How to take zero for z, x and y axis Please more explain

@motoflyte Жыл бұрын

Those +2 attachments on haas machines are garbage...at least the non-trunnion type / single sided unit...like the TRT160. I've been using one for almost 4 years now and it's never produced better than .0015" tolerance. And, haas techs and many other users have said the same thing. It's fine if you use it for workholding and re origin your part every time you move it, but forget about running a full 5 axis routine and getting any kind of accuracy. Perhaps a full trunnion is better...I wouldn't know.

@barleypaw 2 жыл бұрын

I'm confused about setting A axis with part zero set. It seems you are working with a B and C axis. Is this protocol to cover the event of a trunnion setup 90 degrees rotated?

@VeryUsefulVideos Жыл бұрын

It is actually A C. Remember that X, Y, Z relates to A, B, C.