Not many finds me, don't think I'm the algorithms favourite😁. Thanks, I appreciate your comment and glad you liked my shooting board series.

You're welcome. Could be that not many people own a shooting plane and it's maybe not the most ergonomic operation with a standard plane. Otherwise I don't know, I find it very useful.

Thanks! Yes this plane is one of my favourite tools, very versatile😀

Very good idea with a stop rule, it would work brilliantly.

Kul att du uppskattade filmerna!

Thank you! Not so common with long grain shooting boards but this is very useful for many tasks.

Thanks! I understand the concept of your thicknessing jig but I have no plans to build one myself. My plane jigs are mainly about fine tuning pieces for perfect fit, thicknessing is heavy work and that my spiral head jointer/planer handles very well.🙂

@@CarmoniusFinsnickeri no problem thank you.

Do so, it's a quite simple build and very useful for many tasks.

Hi Bruce, no I'm in Sweden. These shooting boards are quite easy to make, maybe except for the miter edge one, so I think you should give it a go. Any questions just ask.

Thanks, glad you appreciated the video. No problems at all with the low angle design. For end grain, low angle is preferred for several reasons, see link below. For edge grain like here, low angle might easier give tearout if it's tricky wood but haven't experienced any problems. www.inthewoodshop.com/ToolReviews/MoreAboutShootingPlanesandTheirBlades.html

@@CarmoniusFinsnickeri Thanks for the response. The LN website demos using their #51 for squaring up parts for small boxes. This is something I want one for, that and making sure laminations for cutting boards are square and flat, which is why I was glad to find your video. I had ideas for how to make it work, but seeing it done really helped. Thanks again for the video and for directing me to that link comparing the two planes. (I do like the look and feel of the LN #51 though)

@@robertfoster1420 you're welcome. I tried both the Veritas and the LN shooting planes. The LN have imo slightly better ergonomics with the handle closer to where the cut takes place, while the Veritas handle is further back. Still prefer the Veritas though due to the low angle.

Thanks! Yes shims is a good idea to reach higher precision and even dimensions on both sides. Usually I can eyeball it to within 0.2mm and that's accurate enough for most of my applications.

Sorry, no plans. But it's a quite simple build. If you watch the final 2 minutes you see the seperate parts. I'm happy to answer questions if you decide to build one.

Carmonius Finsnickeri Thanks! I admire your craftsmanship!😁👍

@@tomlavelle8518 Thanks! As said, give it a go, it's a very useful shooting board. If you're in US it might be easier to source the microjig dovetail clamps and suitable router bit, same concept with routed in tracks as I use. If in europe, axminster sells a router bit that match the rail clamps.