V-Band V.S. Slip On Exhaust Clamps

V-Band V.S. Slip On Exhaust Clamps | AskDap

Рет қаралды 26,841

Күн бұрын

Q - Airs2k - KZfaq - Why are manufacturers not using v-band clamps on exhaust systems? I work on airline and all the pneumatic piping has those clamps. These slip on clamps are poop
For VW and Audi Parts Shop our site HERE:
shopdap.com/
This video was shot on location:
Deutsche Auto Parts Inc.
10308 Bailey Rd
Suite 417
Cornelius, NC. 28031

Пікірлер: 14

@TJ-qz6hr 3 жыл бұрын

This one time at Band Clamp....

@karstgeo7290 4 жыл бұрын

Just did a resonator delete and had to use both! The slip ons are definately easier to deal with when you need a little wiggle room. Good content as usual.

@donventura3844 Жыл бұрын

For turbo downpipe and other in engine bay purposes v bands are great. But anything under the chasis I prefer the low profile nature of a Torca Accuseal. Both are better than flanges any day

@jhonimastersipayung5874 4 жыл бұрын

Is it Norma Clamps?

@donventura3844 Жыл бұрын

Correct norma has the patent on the action bar system.

@repubseatdick 2 жыл бұрын

Use a slip on clamp with a rubber sleeve you fashion yourself out of something you can find

@secretninjawarrior 2 жыл бұрын

costs, costs and fabrication of the ends...cost..... v bands are high pressure clamps for turbine engines.

@ardie72 4 жыл бұрын

2 and half mins to say...its cost.

@TooBlessedToStress88 2 жыл бұрын

Your phat ass could of been grateful he’s demonstrating this for you…

@hollow34 2 жыл бұрын

Isn't that KZfaq in sentence?

@anonypersona3189 Жыл бұрын

That's just the consumer way of looking at it. Cost actually means much more time, expertise, and precision. Anyone can use a band clamp to assemble the exhaust, but using V Clamps can make some set ups 10x more difficult, especially if you have dual pipes right next to each other. You have disassemble the exhaust and pipes, get the right size clamps and flanges, measure precisely to accommodate for the V-clamps extra length, cut the pipes perfectly square, weld on the flanges CAREFULLY without warping them - and you have to do it on both ends, then perfectly line it up and snap them on. Alone, these clamps can cost $50-$80 each too.

@ardie72 Жыл бұрын

@@anonypersona3189 ..yawn.....

@yo_its_devo 4 ай бұрын

Did you miss the entire section about tolerances and how v-bands are less forgiving?