Рет қаралды 4,511
*** PLEASE READ THESE NOTES FIRST ***
This contains important edits / updates.
1. This is not meant to be a start to finish guide for installing a genuine cruise control switch into a YB Kia Rio. Such guides are available elsewhere, and I watched multiple of those myself. This video contains some insights that I learnt when installing the switch into my own Rio. In particular, I’ve tried to address and answer questions that I couldn’t find an answer to in other videos / websites before I installed it. Hopefully this helps you feel more confident in doing the install. In the end, it was quite an easy job and should take you 25-30mins max., but do it slowly and methodically.
2. From 2:00 onwards I mean “screw” not “switch” when I’m referring to the screws. I clearly hadn't had enough coffee that day!
3. At the 3:40 mark, I mention screwing the screw into the plastic until there's 8-10mm of thread showing. After doing my second install for a friend, I realised you could probably afford to go to within about 7mm of thread showing, but please still apply common sense. Personally I think 8-10mm is a little too much and it will be too loose and require more thread cutting after the switch is put into place, which is a little more nerve wracking than cutting the thread with the switch still out.
3. Because I didn’t need to disconnect the airbag, there were no codes for me to clear when I reconnected the battery and started the car. An OBD reader was not required.
Any questions, please ask in the comments!