Spyderco Delica 4 MOD 2 Titanium Scale Kit Installation Instructions

Рет қаралды 735

Lynch Northwest

3 ай бұрын

Learn how to install our custom Spyderco Delica 4 MOD 2 scale kits on your favorite Spyderco Delica 4 knife.

Пікірлер: 12

@JROTCBALL 2 ай бұрын

Have y’all considered doing a Mod3 with the milling on the scale designed to line up better with the warrencliff shaped blade profile? That’d be sweet

@lynchnw 2 ай бұрын

Thanks for the feedback, we had not considered that.

@bryanin602 2 ай бұрын

I kinda like it better with the Wharncliffe blade because it almost locks your finger into that front choil but I can see what you mean. It was 100% designed for the original blade.

@Bisqcateer 2 ай бұрын

Hi Justin, thanks for the video. I just bought a Delica and wasn't looking forward to when I needed to open it up, but it actually looks extremely straightforward from the way you showed. I've always liked the changed profile of these scales, but I actually wish they did not have the drilled holes to outline the blade edge. Would you all consider making a batch run of these Delica scales but without the drilled holes?

@lynchnw 2 ай бұрын

We will consider that suggestion for sure! Thanks for all the feedback.

@mrblackroc1807 Ай бұрын

Just instaled the same kit. Is it normal that i can barely screw in the pivot ? I tightened it with my bare fingers holding the t8 bit. Same for backlock screw

@lynchnw Ай бұрын

We recommend making sure the lock bar pin is not too tight and to make sure the washers do not have any burrs. The burrs occur during installation from Spyderco.

@Warsmith_Honsou 3 ай бұрын

Is there an option for left handed people?

@lynchnw 3 ай бұрын

Not currently, sorry about that. We have considered doing some left handed runs in the future.

@Low-effort-individual 3 ай бұрын

Do these kits come with the hardware or do I need to use the screws from the original knife

@lynchnw 3 ай бұрын

Good question. These kits come with scales, back-spacer, and deep carry clip w/ screw. You will still need the back-lock, pin, blade and hardware from the original donor knife to assemble.

@Low-effort-individual 3 ай бұрын

@@lynchnw sweet sounds like I’ll need to order a hardware replacement kit around the same time thanks for replying