@@bobsmoot2392 wow! That’s awesome.

Glad it helped!

You should make 15 loaded for one guy plus dog. My boat is a 1232 but you should see very similar results. How long of a shaft do you have on your kit?

The mudskipper #0 speed prop is probably what you guys are after it's not the standard 6.5 diameter with a 5 inch pitch it's a 6 inch diameter with a 7 inch pitch might want a stage 1 for the prop should see roughly 20mph should work better for the 1232 then a 1432. The prop should work on the beaver tail I think is what you said you have. I personally don't like the larger d.a. props as easier to break. Most people don't realize mudskipper sells speed props. #0 to #8 in speed props most don't research and doesn't realize pitch is more important then diameter! Interesting video btw. Also have you bent your skegg to keep it from kicking the tail to the left and or right if you in the boat?

@@rncboy2 I haven’t bent the skeg because I was sitting on one side of the boat and I got this boat for the test. Motor is currently on a Carstens bluebill and I stand. Purpose of the video was to show performance improvements against my last video. Not to get top speed per se. I’ll check into the other props!

@grindfestoutdoors Okay makes sense now, sorry about that buddy, just found this video lol so I am new to the channel. That was a half question comment and info to others who read it. Definitely would have worded it differently knowing that. Either way hopefully some of the information is helpful. Definitely will be going back through the other videos to catch myself up to speed on what is going on.

@@rncboy2 no problem at all! I’m glad you’re watching it. I’m always open to feedback. Personally, I think getting those props would be a good idea. Maybe I could convince the other companies to send me props at some point and I’ll test them all.

I got the exhaust from beaver dam. The remainder I got on Amazon. I’ve got a video I’ll upload soon of everything and the install

@@grindfestoutdoors I’ll keep an eye out for the video!

@@nathanhardwick8037 .037 But I don’t think that’s your problem. You shouldn’t be maxing out the engine at 3500rpm with the governor removed. I don’t have my gov removed and it kicks in at about 3700-3800rpm 6.25” seems much too small. Are you running it on the surface?

@grindfestoutdoors I ran it on the surface I ran deep. I was on the water for over an hour trying trying everything. My average was 5mph. It was just me (175lbd) and the dog(60lbs). It kept wanting to stall out at first..so I set the needle on the carb at the last ring. Not sure if your familiar with mikuni carbs. To mee it almost seems as if it's running too lean. But need to pull the plug to verify.

@@nathanhardwick8037 I have not used mikuni just because I’ve heard they have a steep learning curve. My gut says that you should figure out your carb before you change the jet. Is it a new carb?